Abstract:Purpose Gas insulated systems, such as gas insulated lines (GIL), use insulating gas, mostly sulfur hexalfluoride (SF 6 ), to enable a higher dielectric strength compared to e.g. air. However, under high voltage direct current conditions, charge accumulation and electric field stress may occur, which may lead to partial discharge or system failure. Therefore, numerical simulations are used to design the system and determine the electric field and charge distribution. Although the gas conduction shows a more complex current–voltage characteristic compared to solid insulation, the electric conductivity of the SF 6 gas is set as constant in most works. The purpose of this study is to investigate different approaches to address the conduction in the gas properly for numerical simulations. Design/methodology/approach In this work, two approaches are investigated to address the conduction in the insulating gas and are compared to each other. One method is an ion-drift-diffusion model, where the conduction in the gas is described by the ion motion in the SF 6 gas. However, this method is computationally expensive. Alternatively, a less complex approach is an electro-thermal model with the application of an electric conductivity model for the SF 6 gas. Measurements show that the electric conductivity in the SF 6 gas has a nonlinear dependency on temperature, electric field and gas pressure. From these measurements, an electric conductivity model was developed. Both methods are compared by simulation results, where different parameters and conditions are considered, to investigate the potential of the electric conductivity model as a computationally less expensive alternative. Findings The simulation results of both simulation approaches show similar results, proving the electric conductivity for the SF 6 gas as a valid alternative. Using the electro-thermal model approach with the application of the electric conductivity model enables a solution time up to six times faster compared to the ion-drift-diffusion model. The application of the model allows to examine the influence of different parameters such as temperature and gas pressure on the electric field distribution in the GIL, whereas the ion-drift-diffusion model enables to investigate the distribution of homo- and heteropolar charges in the insulation gas. Originality/value This work presents numerical simulation models for high voltage direct current GIL, where the conduction in the SF 6 gas is described more precisely compared to a definition of a constant electric conductivity value for the insulation gas. The electric conductivity model for the SF 6 gas allows for consideration of the current–voltage characteristics of the gas, is computationally less expensive compared to an ion-drift diffusion model and needs considerably less solution time.

Electric Performance of New Non-SF6 Gases and Gas Mixtures for Gas-Insulated Systems

Dynamic Dielectric Strength of C 3 F 7 CN/CO 2 and C 3 F 7 CN/N 2 Gas Mixtures in High Voltage Circuit Breakers

Technical aspects of gas insulated transmission lines and application of new insulating gases

AC breakdown and decomposition products detection characteristics of eco-friendly insulating medium in gas insulated switchgear

The Development of SF6 Green Substitute Gas

Partial discharge detection and diagnosis in gas insulated switchgear: State of the art

Study on Breakdown Characteristics and Attenuation Characteristics of Air Mixed Gas

Analysis of Breaking Characteristics of C4F7N/CO2 Mixture Gas in Circuit Breaker

Motion analysis of spherical metal particle in AC gas-insulated lines: random effects and resistance of the SF6/N2 mixture

New Generation of SF6-Free Medium-Voltage Switchgear for the Electrical Network: Stability and Toxicity Studies of Trans-1,1,1,4,4,4-Hexafluorobut-2-ene with N2 Gas Mixture

Defects and failure types of solid insulation in gas‐insulated switchgear: In situ study and case analysis

Comparison of the Interrupting Capability of Gas Circuit Breaker According to SF6, g3, and CO2/O2 Mixture

Decomposition characteristics of C4F7N-based SF6-alternative gas mixtures

Test methods and results for recent outdoor insulation in Japan

Comparison of simulations of the gas conduction in HVDC GIL by application of nonlinear conductivity model and ion-drift-diffusion model

Conceptual Design and Feasibility Study of Flexible Gas-Insulated Transmission Line Using CF3I Gas Mixture

Research on the Temperature Rise Characteristics of Medium‐Voltage Switchgear under Different Operation Conditions

Intrinsic Hetero-Polar Surface Charge Phenomenon in Environmental Friendly C3F7CN/CO2 Gas Mixture

Insulation resistance under DC stress and electrification characteristics of GIS epoxy insulator

Exploring Eco-Friendly Gas Mixtures for Resistive Plate Chambers: A Comprehensive Study on Performance and Aging

Study on Temperature Rise Characteristics of GIS Disconnector Under Different Operating Conditions