Abstract:The twin-body plasma arc has the decoupling control ability of heat transfer and mass transfer, which is beneficial to shape and property control in wire arc additive manufacturing. In this paper, with the wire feeding speed as a characteristic quantity, the wire melting control ability of twin-body plasma arc was studied by adjusting the current separation ratio (under the condition of a constant total current), the wire current/main current and the position of the wire in the arc axial direction. The results showed that under the premise that the total current remains unchanged (100 A), as the current separation ratio increased, the middle and minimum melting amounts increased approximately synchronously under the effect of anode effect power, the first melting mass range remained constant; the maximum melting amount increased twice as fast as the middle melting amount under the effect of the wire feeding speed, and the second melting mass range was expanded. When the wire current increased, the anode effect power and the plasma arc power were both factors causing the increase in the wire melting amount; however, when the main current increased, the plasma arc power was the only factor causing the increase in the wire melting amount. The average wire melting increment caused by the anode effect power was approximately 2.7 times that caused by the plasma arc power. The minimum melting amount was not affected by the wire-torch distance under any current separation ratio tested. When the current separation ratio increased and reached a threshold, the middle melting amount remained constant with increasing wire-torch distance. When the current separation ratio continued to increase and reached the next threshold, the maximum melting amount remained constant with the increasing wire-torch distance. The effect of the wire-torch distance on the wire melting amount reduced with the increase in the current separation ratio. Through this study, the decoupling mechanism and ability of this innovative arc heat source is more clearly.

Characteristics of bypass coupling twin-wire indirect arc welding with high-speed welding mode

Effect of Bypass Coupling Current on Corrosion Resistance of Twin-Wire Indirect Arc Surfacing Layer

Microstructure and Corrosion Resistance of Stainless Steel Produced by Bypass Coupling Twin-Wire Indirect Arc Additive Manufacturing

Simulation and control of metal droplet transfer in bypass coupling wire arc additive manufacturing

Characteristics of the Electrode Melting Phenomena in Narrow Gap Mag High-Rotating-Speed Arc Welding

Key mechanism of metal transfer and characteristic of cavity evolution during SAW using in-situ X-ray imaging method

Coupled Mechanisms of Arc, Weld Pool and Weld Microstructures in High Speed Tandem TIG Welding

Research on suppression of cross coupled arc oscillation behavior

Research on Arc Interference and Welding Operating Point Change of Twin Wire MIG Welding

Arc Interference Behavior During Twin Wire Gas Metal Arc Welding Process

Arc Behavior and Droplet Transfer of CWW CO2 Welding

Physics Characteristic of Coupling Arc of Twin-Tungsten Tig Welding

Arc Ignition of CWW CO2 Welding in A36 Steel

Effect of energy parameters on droplet transfer behavior and weld formation in laser-arc hybrid welding with cable-type welding wire

Numerical Analysis of Physical Characteristics and Heat Transfer Decoupling Behavior in Bypass Coupling Variable Polarity Plasma Arc

Arc Heating Hot Wire Assisted Arc Welding Technique for Low Resistance Welding Wire

Arc Properties and Droplet Transfer Characteristics in Cable-Type Welding Wire Electrogas Welding

A Study on the Mechanisms of the CWW SAW Process

Research on Arc Interference Mechanism of Multi-wire CO2 Welding

Influence of Interwire Angle on Undercutting Formation and Arc Behavior in Pulsed Tandem Narrow-Gap GMAW

Experimental Study on Wire Melting Control Ability of Twin-Body Plasma Arc