Abstract:This study focuses on understanding the corrosion and tribological behaviour of hybrid aluminium composites in diverse environmental conditions (dry, aqueous and alkaline). The characteristics are compared under corrosive conditions to check the tendency to wear and corrosion for its probable use in marine applications. Eutectic aluminium–silicon (Al–Si) alloys and hybrid aluminium composites enhanced with alumina (6 wt%) and varying weights of graphene nanoplatelets (GNP) (1, 2, 3 wt%) samples were fabricated by spark plasma sintering. The corrosion behaviour of the hybrid composites was investigated by potentiodynamic polarization technique using 3.5 wt% NaCl solution as electrolyte. A chromium-plated chrome steel ball of 10-mm diameter was used for the ball-on-disk test at varying load (50–250 N), sliding velocity 0.12 m/s, sliding distance 120 m, frequency 30 Hz, stroke 2 mm, and test duration 1000 s to evaluate the tribological behaviour. An increase in the corrosion and tribological performance was observed with an increase in GNP concentration in the fabricated hybrid composite sample. Composite sample with 3 wt% of GNP had the highest average electrochemical open-circuit potential value of − 0.731 V, followed by 2 wt% (− 0.743 V), 1 wt% (− 0.747 V) and base (− 0.771 V). The presence of GNP reduced the vulnerability to corrosive degradation as being superhydrophobic, it inhibited the chloride ion attack by offering lesser adsorption of the salt solution on the hybrid composites’ surfaces. The wear mechanism was discussed by interpretation from scanning electron microscopy, energy dispersive X-ray analysis (EDX) and 3D surface profilometry. The formation of carbon protective layer at the interface led to a reduction in coefficient of friction and wear of hybrid composite with 3 wt% of GNP by more than 90% and 60%, respectively, at all environmental conditions as compared to base alloy.

Microstructure and corrosion resistance of solution treated A380-GNPs composites

Effect of Graphene on the Microstructure Evolution and Mechanical Properties of Al–10Si–2Cu–1.5Fe Aluminum Matrix Composites

Effects of Graphene Nanoplates (GNPs) on Microstructure and Corrosion Behavior of ADC12-GNPs Composite

Analysis of the microstructure evolution, enhanced hardness and electrical conductivity of T6 heat-treated A319/graphene composites

Effects of Graphene Nanoplatelets on the Microstructure, Mechanical Properties, and Corrosion Behavior of Spark Plasma Sintered Al + 20 vol.% (TiC + TiB2) Hybrid Composites

Effect of Heat Treatment on Interfacial Bonding and Strengthening Efficiency of Graphene in GNP/Al Composites

Homogeneously Dispersed Graphene Nanoplatelets as Long-Term Corrosion Inhibitors for Aluminum Matrix Composites

Hybrid epoxy-SiO2/GO nanosheets anti-corrosive coating for aeronautic aluminum Al6061-T5

Microstructure Evolution and Properties of Graphene Nanoplatelets Reinforced Aluminum Matrix Composites

Microstructure and oxidation behaviour of graphene nanoplatelets / titanium composites prepared by spark plasma sintering

Effect of Fabrication Parameters on the Performance of 0.5 wt.% Graphene Nanoplates-Reinforced Aluminum Composites

Corrosion Behavior of Graphene Nanosheets Reinforced Magnesium Matrix Composites in Simulated Body Fluids

Synthesis and characterization of graphene nanoplatelets reinforced AA7068 matrix nanocomposites produced by liquid metallurgy route

Thermally Stable Microstructure and Mechanical Properties of Graphene Reinforced Aluminum Matrix Composites at Elevated Temperature

Influence of T6 heat treatment on the microstructure and tribological properties of ADC12-GNPs composites

Microstructure and Mechanical Properties of Graphene Reinforced K418 Superalloy by Selective Laser Melting

Enhanced corrosion performance of ultrasonically shot peened and graphene nanoparticles reinforced squeeze-cast AZ91 magnesium alloy

Preparation and properties of graphene nanoplatelets reinforced aluminum composites

Effects of nanoparticles on the solution treatment and mechanical properties of nano-SiCp/Al-Cu composites

Corrosion and Tribo-Investigations on Alumina–Graphene-Doped Hybrid Aluminium Composites

Corrosion Behavior of Microwave-Sintered Ti6Al6V2Sn Reinforced with Graphene Nanoparticles