Abstract:Thermal rectification devices based on solid-liquid phase change material (PCM) can realize efficient and reversible control of forward and reverse heat flux. In this study, an analytical solution for a shell-and-tube phase change thermal rectifier is derived based on Fourier's law of heat conduction. The validity of the analytical model is confirmed by the numerical model verified by the exact solution of the single-phase Stefan problem. The influence of thermophysical properties, structural parameters, and initial temperature on the dynamic and static thermal rectification effects of the shell-and-tube heterojunction composed of polydimethylsiloxane (PDMS) and hexadecane (C16) is investigated and optimized. Results indicate that the proposed analytical model for the shelland-tube phase change thermal rectifier enables rapid and precise prediction of thermal rectification effects. The presence of solid-liquid phases of C16 under forward and reverse heat transfer modes reduced the thermal resistance difference, resulting in poor initial rectification performance (only about 1.17). The optimized thermal rectification effect is significantly increased to 1.56, which is significantly improved by 33.56 %. Moreover, the dynamic rectification effect of the shell-and-tube thermal rectifier is notably higher than the static rectification effect. The average dynamic thermal rectification ratio within the first 50 s before and after optimization is 2.19 and 7.80, respectively, which is several times higher than the static thermal rectification ratio. This paper further analyzes the impact of initial temperature and finds that an increase in initial temperature can further enhance the dynamic thermal rectification effect. Raising the initial temperature to 5 K above the phase change temperature can increase the improvement of the dynamic rectification effect to 256.36 % in the first 50 s. The significance of this study lies in its potential to advance the understanding and practical application of thermal rectification based on PCM.

Enhancement of thermal rectification effect based on zigzag interfaces in bi-segment thermal rectifier using bulk materials

Enhancement of Thermal Rectification by Asymmetry Engineering of Thermal Conductivity and Geometric Structure for Multi-Segment Thermal Rectifier

Far-field radiative thermal rectifier based on nanostructures with vanadium dioxide.

Thermal rectification mechanism of composite cylinders with temperature and stress-dependent interface thermal resistance

Numerical Modeling and Optimization of the Segmented PbTe–BiTe-based Thermoelectric Leg

A Brief Review on the Recent Experimental Advances in Thermal Rectification at the Nanoscale

Giant radiative thermal rectification using an intrinsic semiconductor film

Thermal Rectification At The Bimaterial Nanocontact Interface

Review of thermal rectification experiments and theoretical calculations in 2D materials

Transient thermal regulation mechanisms of composite structures with interface thermal resistance

Multilayer Graphene-Based Thermal Rectifier with Interlayer Gradient Functionalization

Analysis and Optimization of Dynamic and Static Thermal Rectification in Shell-and-tube Phase Change Thermal Rectifiers

Far-field radiative thermal rectification with bulk materials

Thermal rectification based on thermochromic materials

Asymmetric Thermal Rectifier with Designed In-Plane Temperature Gradient Zones for Thermoelectric Generator

The design of a thermal rectifier

An oxide thermal rectifier

Thermal Switch and Thermal Rectification Enabled by Near-Field Radiative Heat Transfer Between Three Slabs

Giant Thermal Transport Tuning at a Metal/Ferroelectric Interface

Thermal Rectification in Silicon Nanowires with Mass Gradients

Highly-efficient radiative thermal rectifiers based on near-field gap variations