Abstract:Systematic errors induced by distortions in the pump pulse of conventional Brillouin distributed fiber sensors are thoroughly investigated. Experimental results, supported by a theoretical analysis, demonstrate that the two probe sidebands in standard Brillouin optical time-domain analyzers provide a non-zero net gain on the pump pulse, inducing severe distortions of the pump when scanning the pump-probe frequency offset, especially at high probe power levels. Compared to the impact of non-local effects reported in the state-of-the-art, measurements here indicate that for probe powers in the mW range (below the onset of amplified spontaneous Brillouin scattering), the obtained gain and loss spectra show two strong side-lobes that lead to significant strain/temperature errors. This phenomenon is not related to the well-known spectral hole burning resulting from pump depletion, but it is strictly related to the temporal and spectral distortions that the pump pulse experiences when scanning the Brillouin gain/loss spectrum. As a solution to this problem, a novel scanning scheme for Brillouin sensing is proposed. The method relies on a fixed frequency separation between the two probe sidebands, so that a flat zero net gain is achieved on the pump pulse when scanning the pump-probe frequency offset. The proposed technique is experimentally validated, demonstrating its ability to completely cancel out non-local effects up to a probe power ultimately limited by the onset of amplified spontaneous Brillouin scattering. The method allows for one order of magnitude improvement in the figure-of-merit of optimized long-range Brillouin distributed fiber sensors, enabling measurements along a 100 km-long sensing fiber with 2 m spatial resolution and with no need of added features for performance enhancement.

Segmental Frequency Modulated Probe for Non-Local Effect Reduction in a Pulse-Coded Brillouin Optical Time Domain Analyzer

Non-local effect in Brillouin optical time-domain analyzer based on Raman amplification

Theoretical Investigations on the Non-Local Effect in A Long-Distance Brillouin Optical Time-Domain Analyzer Based on Bi-Directional Raman Amplification

Novel scanning method for distortion-free BOTDA measurements

Frequency Domain Staring Pump-Probe Technique for Brillouin Gain/Loss Spectrum Measurement

Using Pulse with A Dark Base to Achieve High Spatial and Frequency Resolution for the Distributed Brillouin Sensor

Distributed Pound-Drever-Hall Technique for Fast Brillouin Optical Time Domain Analysis

Kilometers-range dark-pulse Brillouin optical time domain analyzer with centimeters spatial resolution

Brillouin Optical Time Domain Analyzer Based on Bi-Directional Raman Amplification

Efficient Demodulation of Brillouin Phase Spectra and Performance Enhancement in BOTDA Incorporating Phase Noise Elimination

Extending the Sensing Range of Brillouin Optical Time-Domain Analysis Combining Frequency-Division Multiplexing and In-Line EDFAs

Signal-To-Noise Ratio Improvement In Brillouin Optical Correlation Domain Analysis Combining Brillouin Gain And Loss Effects

Enhanced Sensing Performance in Long Distance Brillouin Optical Time-Domain Analyzer Based on Raman Amplification: Theoretical and Experimental Investigation

Performance of long-range loss-mechanism Brillouin optical-fiber time-domain analysis

Towards fast sensing along ultralong BOTDA: flatness enhancement by utilizing injection-locked dual-bandwidth probe wave

Brillouin-based random fiber optic delay line

Extending the Sensing Distance of a Single-end Random-access BOTDA for Dynamic Sensing

Simulation Analysis on the Simultaneous Deployment of Brillouin Gain and Loss in Coded Brillouin Optical Time Domain Analysis (BOTDA) Fiber Sensor

150 Km Fast BOTDA Based on the Optical Chirp Chain Probe Wave and Brillouin Loss Scheme.

Compensating Model of Nonlocal Effects in a Brillouin Optical Time-Domain Analysis System

Performance Limit of A Multi-Frequency Probe Based Coherent Optical Time Domain Reflectometry Caused by Nonlinear Effects