Abstract:Systematic errors induced by distortions in the pump pulse of conventional Brillouin distributed fiber sensors are thoroughly investigated. Experimental results, supported by a theoretical analysis, demonstrate that the two probe sidebands in standard Brillouin optical time-domain analyzers provide a non-zero net gain on the pump pulse, inducing severe distortions of the pump when scanning the pump-probe frequency offset, especially at high probe power levels. Compared to the impact of non-local effects reported in the state-of-the-art, measurements here indicate that for probe powers in the mW range (below the onset of amplified spontaneous Brillouin scattering), the obtained gain and loss spectra show two strong side-lobes that lead to significant strain/temperature errors. This phenomenon is not related to the well-known spectral hole burning resulting from pump depletion, but it is strictly related to the temporal and spectral distortions that the pump pulse experiences when scanning the Brillouin gain/loss spectrum. As a solution to this problem, a novel scanning scheme for Brillouin sensing is proposed. The method relies on a fixed frequency separation between the two probe sidebands, so that a flat zero net gain is achieved on the pump pulse when scanning the pump-probe frequency offset. The proposed technique is experimentally validated, demonstrating its ability to completely cancel out non-local effects up to a probe power ultimately limited by the onset of amplified spontaneous Brillouin scattering. The method allows for one order of magnitude improvement in the figure-of-merit of optimized long-range Brillouin distributed fiber sensors, enabling measurements along a 100 km-long sensing fiber with 2 m spatial resolution and with no need of added features for performance enhancement.

Compensating Model of Nonlocal Effects in a Brillouin Optical Time-Domain Analysis System

Brillouin Optical Time Domain Analysis Incorporating with Backward Rayleigh Light Detection.

Theoretical Investigations on the Non-Local Effect in A Long-Distance Brillouin Optical Time-Domain Analyzer Based on Bi-Directional Raman Amplification

Non-local effect in Brillouin optical time-domain analyzer based on Raman amplification

Compensation of the frequency fluctuations of light sources in distributed Brillouin sensor.

Segmental Frequency Modulated Probe for Non-Local Effect Reduction in a Pulse-Coded Brillouin Optical Time Domain Analyzer

Performance of long-range loss-mechanism Brillouin optical-fiber time-domain analysis

Distributed Strain Sensing Based on Combination of Brillouin Gain and Loss Effects in Brillouin Optical Correlation Domain Analysis

Brillouin Optical Time Domain Analyzer Based on Bi-Directional Raman Amplification

Signal-To-Noise Ratio Improvement In Brillouin Optical Correlation Domain Analysis Combining Brillouin Gain And Loss Effects

Optimization of Brillouin Optical Correlation Domain Analysis System Based on Intensity Modulation Scheme

Optimization of Brillouin Optical Correlation Domain Analysis Based on Intensity Modulation to Enlarge the Measurable Strain Limit

Spatial-division Multiplexed Brillouin Distributed Sensing Based on a Heterogeneous Multicore Fiber

Brillouin Optical Time Domain Analysis with Phase-Modulated Probe and Time-of-Flight Servo Loop

Equidistance Difference Optimum Method to Enhance Measuring Space of Brillouin Optical Fiber Sensor

Brillouin Optical Time Domain Analysis System Based on Raman Amplification and Semiconductor Optical Amplifier

Influence of Optical Simple Pulse Coding on the Brillouin Optical Time Domain Analyzer Based on Bi-Directional Raman Amplification

Effects of Intensity Modulation of Light Source on Brillouin Optical Correlation Domain Analysis

Extending the Sensing Range of Brillouin Optical Time-Domain Analysis Combining Frequency-Division Multiplexing and In-Line EDFAs

System optimization of a long-range Brillouin-loss-based distributed fiber sensor.

Novel scanning method for distortion-free BOTDA measurements