Abstract:A desirable process for realizing a low-carbon society is the direct conversion of dilute CO2 from flue gases or air into highly concentrated hydrocarbons without a need for separate CO2 capture and purification processes. In this study, we investigated the performance of integrated CO2 capture and reduction to CH4 over Ni-based dual-functional catalysts promoted with Na, K, and Ca. Ni/Na-γ-Al2O3 exhibited the highest activity for integrated CO2 (5% CO2) capture and reduction, achieving high CO2 conversion (>96%) and CH4 selectivity (>93%). In addition, very low-concentration CO2 (100 ppm CO2) was successfully converted to 11.5% CH4 at the peak point (>1000 times higher concentration than that of the supplied CO2) over Ni/Na-γ-Al2O3. The Ni-based dual-functional catalyst exhibited a high CO2 conversion exceeding 90%, even when 20% O2 was present during CO2 capture. Furthermore, an increased operation pressure had positive impacts on both CO2 capture and CH4 formation, and these advantageous effects were also observed when CO2 concentration was at the level of atmospheric CO2 (100–400 ppm). As the pressure increased from 0.1 to 0.9 MPa, CH4 production capacity with 400 ppm CO2 was enhanced from 111 to 160 μmol gcat–1. This approach in combination with the efficient catalyst shows encouraging potential for CO2 utilization, enabling direct air capture-conversion to value-added chemicals.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssuschemeng.0c07162?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssuschemeng.0c07162</a>.Experimental setup, several cycles of integrated CO2 capture and reduction, XRD, N2 adsorption–desorption, H2-TPR, CO2-TPD, Ar-TPD, effects of temperature and flow rate, CO2 capture efficiency (<a class="ext-link" href="/doi/suppl/10.1021/acssuschemeng.0c07162/suppl_file/sc0c07162_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Direct and continuous conversion of flue gas CO2 into green fuels using dual function materials in a circulating fluidized bed system

Integrated CO2 capture and selective conversion to syngas using transition-metal-free Na/Al2O3 dual-function material

CO2 Capture and In-Situ Conversion: Recent Progresses and Perspectives

Enhanced Activity of Integrated CO 2 Capture and Reduction to CH 4 under Pressurized Conditions toward Atmospheric CO 2 Utilization

Integrated CO2 capture and methanation from the intermediate-temperature flue gas on dual functional hybrids of AMS/CaMgO||Ni Co

Continuous CO 2 Capture in a Circulating Fluidized Bed Using Supported Amine Sorbents

Flue-to-fuel: Bio-integrated carbon capture and utilization of dilute carbon dioxide gas streams to renewable methane

An Integrated Carbon Dioxide Capture and Methanation Process

Heterojunction-redox Catalysts of FexCoyMg10CaO for High-Temperature CO2 Capture and in Situ Conversion in the Context of Green Manufacturing

Material design and prospect of dual-functional materials for integrated carbon dioxide capture and conversion

Integrated and Automated: Liquid Metal‐based System for Full Cycle CO2‐to‐Carbon Conversion (Adv. Energy Mater. 26/2024)

In Situ Spectroscopic Study of CO2 Capture and Methanation over Ni-Ca Based Dual Functional Materials

Uncovering Hydrogen-to-carbon Ratio for Integrated CO2 Capture and Reverse Water-Gas Shift Reaction Through MFB-TGA-MS Analysis

The integrated approach of carbon capture, utilization, and storage via CO 2 mineralization for the removal of fly ash, bottom ash, and exhaust gas―A case study of circulating fluidized bed combustion

Integrated CO2 capture and In-Situ methanation by efficient dual functional Li4SiO4@Ni/CeO2

High-rate and selective conversion of CO2 from aqueous solutions to hydrocarbons

An Experimental and Kinetic Modeling Study of CO2 Hydrogenation to CO over Cu-Al Catalyst Utilizing MFB-TGA-MS

Mechanistic Study of Integrated CO2 Capture and Utilization over Cu and Al-modified Calcined Limestone with High Stability Using MFB-TGA-MS

An investigation of the Ni/carbonate interfaces on dual function materials in integrated CO2 capture and utilisation cycles

Continuous Gas-to-Liquid Conversion for Carbon-Efficient Electroreduction of CO2

Integration of membrane contactors and catalytic solvent regeneration for efficient carbon dioxide capture