Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

Temperature-Dependent SWCC Model for Unsaturated Soil

Influences Affecting the Soil-Water Characteristic Curve

Computation of one-dimensional consolidation of unsaturated soil with linear soil-water characteristic curve

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Study On Soil-Water Characteristic Curves Of Unsaturated Silty Clay Of An Old Landfill Cover

Semi-analytical solution of pore-water pressure in unsaturated ground and infinite slope considering highly nonlinear soil hydraulic properties

A Unified Thermo-Mechanical Bounding Surface Model for Saturated Clay and Sand

Simplified soil water characteristic surface (SWCS) model and its applications to seepage analysis of unsaturated soil

Estimating soil water retention curves from thermal conductivity measurements: A percolation-based effective-medium approximation

A modified model predicting the hydraulic properties of variably saturated soil accounting for film and capillary flow

Temperature effects on the hydraulic properties of unsaturated rooted soils

Thermo-Hydro-Mechanical Coupling Model of Unsaturated Soil Based on Modified VG Model and Numerical Analysis

Exact Solutions for Investigating Thermal Response of Saturated Soil Induced by Temperature Change

Parameterization of soil freezing characteristic curve for unsaturated soils

A fractal hydraulic model for water retention and hydraulic conductivity considering adsorption and capillarity

Soil water isotherm model for particle surface sorption and interlamellar sorption

Numerical modeling of water–heat–vapor–salt transport in unsaturated soil under evaporation

The prediction of the soil freezing characteristic curve using the soil water characteristic curve

Estimating soil water retention curves over the entire saturation range: A thermal conductivity-based approach

A Bound Water Model for Numerical Simulation of SWCC in the Wide Suction Range Based on DDA

Prediction of the soil-water characteristic curve based on the specific surface area of fine-grained soils