Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

Estimating soil water retention curves over the entire saturation range: A thermal conductivity-based approach

Estimating soil water retention curves from thermal conductivity measurements: A percolation-based effective-medium approximation

Determination of Soil Water Retention Curves from Thermal Conductivity Curves, Texture, Bulk Density, and Field Capacity

Estimating Soil Water Retention Curves from Soil Thermal Conductivity Measurements

Influences Affecting the Soil-Water Characteristic Curve

Semi-analytical solution of pore-water pressure in unsaturated ground and infinite slope considering highly nonlinear soil hydraulic properties

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Approaches for Estimating Soil Water Retention Curves at Various Bulk Densities with the Extended Van Genuchten Model

Extrapolative Capability of Two Models That Estimating Soil Water Retention Curve Between Saturation and Oven Dryness.

Modeling Soil Water Retention Curves in the Dry Range Using the Hygroscopic Water Content

An Implicit Model for Soil Thermal Conductivity and Matric Potential

A graph-based approach for modeling the soil–water retention curve of granular soils across the entire suction range

Evaluation of Three Models That Describe Soil Water Retention Curves from Saturation to Oven Dryness

A Hysteretic Model Considering Contact Angle Hysteresis for Fitting Soil‐Water Characteristic Curves

Estimating Soil Water Suction from Texture, Bulk Density and Electrical Resistivity

Weibull distribution models for describing soil hydraulic properties over the entire matric suction range

A Generalized Relationship Between Thermal Conductivity and Matric Suction of Soils

A simple model to predict hydraulic conductivity in medium to dry soil from the water retention curve

Predicting hysteresis loops of the soil water characteristic curve from initial drying

Modelling soil-water retention curves subject to multiple wetting-drying cycles: An approach for expansive soils

An Improved Model for Predicting Soil Thermal Conductivity from Water Content at Room Temperature