Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

A Bound Water Model for Numerical Simulation of SWCC in the Wide Suction Range Based on DDA

Numerical Solution and Analysis of One-dimensional Consolidation of Unsaturated Soil with SWCC

Computation of one-dimensional consolidation of unsaturated soil with linear soil-water characteristic curve

Hierarchical Multiscale Modeling of Fluid-Saturated Soils

Influences Affecting the Soil-Water Characteristic Curve

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Analysis and Inspection on Siltation of Intercepting Combined Sewer System

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

Simplified soil water characteristic surface (SWCS) model and its applications to seepage analysis of unsaturated soil

A Multi-Layer SPH Method to Simulate Water-Soil Coupling Interaction-Based on a New Wall Boundary Model

An extended discontinuous deformation analysis (DDA) for simulation of grouting reinforcement in a water-rich fractured rock tunnel

Temperature-Dependent SWCC Model for Unsaturated Soil

A universal soil–water characteristic curve model based on the particle size distribution and fractal theory

A novel framework for deriving water retention behavior of multimodal unsaturated soils based on pore size distribution data

Development of a Coupled DDA–SPH Method and Its Application to Dynamic Simulation of Landslides Involving Solid–Fluid Interaction

Prediction of the soil-water characteristic curve based on the specific surface area of fine-grained soils

Back-Calculated Soil–Water Characteristic Curve from Fluid Flow Data

Approaches for predicting the soil-water characteristic curves of compacted quartz sand based on particle packing theory

1D-2D Coupled Numerical Model for Shallow-Water Flows

Weibull distribution models for describing soil hydraulic properties over the entire matric suction range

Model test of soil deformation response to draining-recharging conditions based on DFOS