Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

A novel framework for deriving water retention behavior of multimodal unsaturated soils based on pore size distribution data

Influences Affecting the Soil-Water Characteristic Curve

A new water retention model that considers pore non-uniformity and evolution of pore size distribution

A graph-based approach for modeling the soil–water retention curve of granular soils across the entire suction range

Experimental and modeling study of water-retention behavior of fine-grained soils with dual-porosity structures

Modelling soil-water retention curves subject to multiple wetting-drying cycles: An approach for expansive soils

A novel equation for simulating the bimodal soil–water retention curve of unsaturated soils

Semi-analytical solution of pore-water pressure in unsaturated ground and infinite slope considering highly nonlinear soil hydraulic properties

Fractal-based hydraulic model of unsaturated flow in deformable soils considering the evolution of pore size distribution

Determining the soil-water retention curve using mercury intrusion porosimetry test in consideration of soil volume change

Modelling the water retention behaviour of anisotropic soils

A universal soil–water characteristic curve model based on the particle size distribution and fractal theory

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Investigating the effect of porosity on the soil water retention curve using the multiphase Lattice Boltzmann Method

Intrinsic Relationship between Specific Surface Area and Soil Water Retention

Exploring the effect of volume change on capillary soil water retention in an undisturbed silty clay: an experimental and modeling approach

Modeling of Hysteretic Behavior of Soil–Water Retention Curves Using an Original Pore Network Model

Simplified soil water characteristic surface (SWCS) model and its applications to seepage analysis of unsaturated soil

A Modular Framework for Modeling Unsaturated Soil Hydraulic Properties Over the Full Moisture Range

A soil-brine retention model for wetting processes considering the hysteresis effects

Experimental and modeling study of shear strength of unsaturated fine-grained soils with bi-modal water-retention characteristics