Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

A soil-brine retention model for wetting processes considering the hysteresis effects

Influences Affecting the Soil-Water Characteristic Curve

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Modelling the evolution of water retention hysteresis loops during soil deformation based on the ink‐bottle effect

Modelling soil-water retention curves subject to multiple wetting-drying cycles: An approach for expansive soils

A new water retention model that considers pore non-uniformity and evolution of pore size distribution

An Empirical Soil Water Retention Model Based on Probability Laws for Pore‐size Distribution

Simulation of hysteresis in soil–water retention with a correlation between the invading pressure to the governing effective flow area

Modeling of Hysteretic Behavior of Soil–Water Retention Curves Using an Original Pore Network Model

Experimental and modeling study of water-retention behavior of fine-grained soils with dual-porosity structures

Modelling the water retention behaviour of anisotropic soils

Derivation of soil water retention curve incorporating electrochemical effects

Wettability and Hysteresis Effects on Water Sorption in Relatively Dry Soil

A novel framework for deriving water retention behavior of multimodal unsaturated soils based on pore size distribution data

A graph-based approach for modeling the soil–water retention curve of granular soils across the entire suction range

Exploring the effect of volume change on capillary soil water retention in an undisturbed silty clay: an experimental and modeling approach

A Hysteretic Model Considering Contact Angle Hysteresis for Fitting Soil‐Water Characteristic Curves

Predicting hysteresis loops of the soil water characteristic curve from initial drying

Numerical modeling of water–heat–vapor–salt transport in unsaturated soil under evaporation

Soil water isotherm model for particle surface sorption and interlamellar sorption

A Particle-Water Based Model for Water Retention Hysteresis