Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

Exploring the effect of volume change on capillary soil water retention in an undisturbed silty clay: an experimental and modeling approach

Effect of Suction Change on Water Content and Total Volume of an Expansive Clay

Influences Affecting the Soil-Water Characteristic Curve

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

Wetting-induced Softening Behavior of an Unsaturated Expansive Clay

Experimental and modeling study of water-retention behavior of fine-grained soils with dual-porosity structures

Modelling the evolution of water retention hysteresis loops during soil deformation based on the ink‐bottle effect

A graph-based approach for modeling the soil–water retention curve of granular soils across the entire suction range

A fractal hydraulic model for water retention and hydraulic conductivity considering adsorption and capillarity

A new water retention model that considers pore non-uniformity and evolution of pore size distribution

Influences of ink-bottle effect evolution on water retention hysteresis of unsaturated soils: An experimental investigation

Diffusion Hysteresis in Unsaturated Porous Media: A Microfluidic Study

Effects of pore structure on the hysteretic water retention behaviour of silty sand at different stresses

A modified model predicting the hydraulic properties of variably saturated soil accounting for film and capillary flow

Modelling soil-water retention curves subject to multiple wetting-drying cycles: An approach for expansive soils

Study On Soil-Water Characteristic Curves Of Unsaturated Silty Clay Of An Old Landfill Cover

An effective stress-based approach to modeling the hydro-mechanical behavior of unsaturated soils

Microstructural insight into the hysteretic water retention behavior of intact Mile expansive clay

Experimental and discrete element modeling study on suction stress characteristic curve and soil–water characteristic curve of unsaturated reticulated red clay

Monotonic and Cyclic Characteristics of K0-Consolidated Saturated Soft Clay under a Stress Path Involving a Variable Confining Pressure

Determining the soil-water retention curve using mercury intrusion porosimetry test in consideration of soil volume change