Abstract:A digital deconvolution method with pile-up reconstruction has been proposed for scintillator detectors for high rate photon-counting X-ray imaging applications. The detector signal was modeled as an exponential decay waveform convoluted with the single photon response of the SiPM detector. An impulse signal can be obtained by digital deconvolution (unfolding) with much shorter duration, which was then used for energy estimation followed by a trapezoid filter and pile-up discrimination The whole digital deconvolution algorithm has been synthesized and verified by both SIMULINK simulation and experimental tests. The prototype of the detector and the readout electronics were developed for demonstration, using 3 mm x 3 mm x 10 mm LYSO scintillator coupled with a 3 mm x 3 mm SenSL SiPM. A 14 bit, 100 MSPS ADC was used to sample the analog waveform and the digital filter was implemented in a Xilinx Kintex 7 FPGA. The signal width was shortened from similar to 250 ns to 10 similar to 20 ns and then was shaped into trapezoidal pulse with 100 ns width. The energy was estimated from the trapezoid top for better signal collection and noise rejection. The unfolded pulses were used for pile-up discrimination and to reconstruct two pile-up signals from the overlapped trapezoid outputs. The energy performance of the prototype system was firstly validated by measuring the energy spectrums of Am-241, Co-57, Na-22 and Cs-137 radiation sources. The energy resolutions were measured to be 36.9%, 29.9%, 13.9% and 12.9% respectively at 59.5 keV, 122 keV, 511 keV and 662 keV in FWHM. High rate performance was evaluated by an X-ray generator. The maximum output counting rate was measured to 5.36 Mcps without saturation, comparing with the saturated counting rate of 2.34 Mcps using the original LYSO signals The saturation counting rate using digital deconvolution was estimated to be up to similar to 7 Mcps fitted with the paralyzable dead time model, corresponding to similar to 20 Mcps input count rate.

Fast Coincidence Filter for Silicon Photomultiplier Dark Count Rate Rejection

A simple model for multiple coincidence SiPM dark noise

CLARO-CMOS, a very low power ASIC for fast photon counting with pixellated photodetectors

A Digital Silicon Photomultiplier

Fast Single-Quantum Measurement with a Multi-Amplifier Sensing Charge-Coupled Device

Digital Deconvolution Of Scintillation Detector Signals For High Rate Photon-Counting X-Ray Imaging Applications

Architecture-Level Optimization on Digital Silicon Photomultipliers for Medical Imaging

The Fast Stochastic Matching Pursuit for Neutrino and Dark Matter Experiments

Future use of silicon photomultiplier for KAOS at MAMI and PANDA at FAIR

Comparison of readout systems for high-rate silicon photo-multiplier applications

True Random Number Generation Based on Arrival Time and Position of Dark Counts in a Multichannel Silicon Photomultiplier.

A method for characterizing after-pulsing and dark noise of PMTs and SiPMs

A Fast Front-end Readout Design for NICA-MPD Shashlik Electromagnetic Calorimeter

Integrated Active Quenching Circuit for high-rate and distortionless SPAD-based time-resolved fluorescence applications

High-resolution coincidence counting system for large-scale photonics applications

A simulation framework for APD, SiPM, and MPPCs

Design and Characterization of a Silicon Photomultiplier in 0.35- ${\mu }\text{m}$ CMOS

A Count-Rate Recovery Method for Photon Counting X-ray Detectors Using Scintillator/SiPM

A Novel Segmented SiPM Combined With Amplifiers on One Chip With Improved Single-Photon Timing Resolution in 0.35-μm CMOS

Comparison of readout systems for high-rate silicon photomultiplier applications