Abstract:603 Objectives Digital Silicon Photomultiplier has recently emerged as a promising photodetector for ToF PET systems. It not only addresses a number of challenges encountered by analog SiPM such as power consumption and noise susceptibility, but also provides additional benefits including low cost and possibility to monolithically integrate the single-photon avalanche photodiode (SPAD) on the same substrate with complex circuitry[1-4]. In this study, a high-resolution, ultra-low power time-to-digital converter (TDC) was implemented to push the limit of timing resolution and improve image quality[5]. Methods Our SPAD array is fabricated in 130nm CMOS technology, using an n+/p-well junction[6]. A guard ring structure is formed to suppress the premature edge breakdown[7]. An improved passive-quenching, active-reset front-end circuit is coupled to each SPAD cell to disable noisy cells. Fig.1(a) shows the layout of our 8x8 SPAD array. Our TDC employs the Vernier Gated Ring Oscillator to improve the time resolution and reduces power consumption by a gated-mode operation. Fig.1(b) gives the TDC layout. Results The prototype chip is fabricated in standard 130nm CMOS, achieving 7.3ps resolution, 11ps precision, 1.2mW power consumption and 0.03mm2 area. A rms integral nonlinearity(INL) of 1.2LSB is obtained with the help of INL look-up-table calibration. Table I compares the performance with recent relevent works. Conclusions The design and characterization of a dSiPM prototype fabricated in a 130 nm standard CMOS is reported. It comprises of an 8x8 SPAD array and a high-resolution TDC, whose compact size makes it suitable for an array configuration. For the future work, the SPAD array and TDC will be coupled to scintillation crystals to evaluate energy resolution and time resolution for ToF PET imaging. Research Support The authors gratefully acknowledge support from the Canada Research Chair program, NSERC of Canada, CFI, FedDev Ontario, NSERC ResEau strategic network, NCE IC-IMPACTS and CMC Microsystems.

A Digital Silicon Photomultiplier

The silicon photomultiplier: fundamentals and applications of a modern solid-state photon detector

Test Beam Characterization of a Digital Silicon Photomultiplier

4D-tracking with digital SiPMs

Study of Silicon Photomultipliers and Applications

Design and Characterization of a Silicon Photomultiplier in 0.35- ${\mu }\text{m}$ CMOS

Architecture-Level Optimization on Digital Silicon Photomultipliers for Medical Imaging

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70 μm pixel pitch

Advance in Silicon Photomultiplier for All-Digital Positron Emission Tomography

Monolithic MHz-frame rate digital SiPM-IC with sub-100 ps precision and 70$~μ$m pixel pitch

Characterization of Silicon Photomultipliers for PET Imaging

Design considerations for a new generation of SiPMs with unprecedented timing resolution

Current Status and Development of CMOS SiPM for Scintillator-Based Radiation Detectors Toward All-Digital Sensors [Invited]

Development of a High Performance Digital Silicon Photomultiplier (dSiPM) for ToF PET Imaging

Position-Sensitive Silicon Photomultiplier Arrays with Large-Area and Sub-Millimeter Resolution

Progress in the Development of Silion Photomultipliers Electrophotonic Detector Based on Nuclear Medicine Imaging

A Novel Segmented SiPM Combined With Amplifiers on One Chip With Improved Single-Photon Timing Resolution in 0.35-μm CMOS

Silicon photomultiplier arrays - a novel photon detector for a high resolution tracker produced at FBK-irst, Italy

High-speed Photon-Number-resolving Detection Via a GHz-gated SiPM

CMOS SPAD sensor chip for the readout of scintillating fibers

Time resolution and efficiency of SPADs and SiPMs for photons and charged particles