Abstract:The strength mechanism of jointed rocks remains poorly understood. In this paper, direct shear tests were performed on three rock types (intact, continuous jointed, discontinuous jointed rocks) using similar brittle materials and monitored using an acoustic emission device. The undulation angles of the continuous joints and dip angles of the discontinuous joints were 0°, 30°, 45°, and 60°. The results show that the failure mode of the continuous jointed rocks is controlled by the undulation angle and normal stress conditions. Under low normal stress (< 0.3 MPa), the continuous jointed rocks underwent four stages: nonlinear compression densification; linear elastic deformation; sawtooth fracture; and residual section slip. The strength of the continuous jointed rocks reached a maximum at an undulation angle of 45° under low normal stress. The dip angle and rock bridge fracture mode differ during the shearing process of discontinuous jointed rock, which underwent four stages including non-linear compression (crack closure), linear deformation (fine crack extension), non-linear deformation (crack extension penetration), and slip of the penetration surface. The shear strength of the discontinuous jointed rock initially decreased with increasing dip angle to a minimum at 45° and then increased. The acoustic emission ring count, energy, and amplitude results are in good agreement with the rock-shearing process. The investigated acoustic emission parameters reached maxima prior to the peak strength, and crack development within the rock was most intense prior to the continuous-slip damage. The acoustic emission reaches a minimum peak amplitude for a joint dip angle of 45°, which is consistent with the lowest rock strength at this angle in both intact and discontinuous jointed rock.

Shearing Damage Evolution of Natural Rock Joints with Different Wall Strengths

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

Method for Visualizing the Shear Process of Rock Joints Using 3D Laser Scanning and 3D Printing Techniques

Damage Evolution of Rocks Containing a Set of Cross-Joints Based on Acoustic Emission Characteristics

Shear behavior of two-order morphology in rock joints

Experimental Technology for the Shear Strength of the Series-Scale Rock Joint Model

Historical shear deformation of rock fractures derived from quantitative three-dimensional description of fracture surfaces on digital outcrop models (DOMs)

On Size Effect of Rock Joints Roughness Based on Varied Statistical Methods

Shear damage mechanisms of jointed rock mass: a macroscopic and mesoscopic study

Failure Characteristics and Scale in a Sandstone Joint Subjected to Direct Shear Testing: Experimental Investigation with Acoustic Emission Monitoring

Experimental study on post-peak stick-slip failure of three different rock joints under direct shear tests

Study on Mechanical Model for Postpeak Shear Behavior of Rock Joints Based on Degradation Characteristics of the 3D Morphology

Natural joint effect on mechanical characteristics and fracture evolution of In-Site rocks under uniaxial compression

Mechanical failure analysis during direct shear of double-joint rock mass

Shear failure and mechanical behaviors of granite with discontinuous joints under dynamic disturbance: laboratory tests and numerical simulation

Experimental Study on Shear Failure Characteristics of Jointed Rock Mass Based on Direct Shear Tests and Digital Image Correction Techniques

Development of a shear strength model for a rock mass containing a complex fracture system based on direct shear tests: a case study

Shear fracture behavior and damage constitutive model of rock joints considering the effect of pre-peak cyclic loading

Experimental study on the shear and acoustic emission characteristics of jointed rocks

Numerical Investigations on Shear Behavior and Failure Mechanism of Non-persistent Jointed Rocks

Technical path of model reconstruction and shear wear analysis for natural joint based on 3D scanning technology