Abstract:Chemical anchor effect is an efficient route for polysulfides immobilization to enhance the performance of Li-S battery. Transition metal oxides are suitable chemical anchor matrix as Lewis acid coordinated with sulfur atoms in the form of Lewis base. Ion bonds may also be formed between anions in transition metal compounds and lithium ions in lithium polysulfides alleviating the shuttle effect. Reducing their crystal sizes to expose more surface active sites and expand surface areas is pivotal to sufficiently immobilize polysulfides. Here, an optimized GFM-2 composite was fabricated, where the 20 nm metal oxide particles aggregated by the 3-5 nm Fe2O3 and Mn3O4 binary crystals are uniformly distributed on the reduced graphene oxide (rGO) nanosheets. A high specific surface area up to 144.9 m(2) g(-1) was obtained for the GFM-2. The modified sulfur@rGO (S@G) cathode obtained by mixing S@G and GFM-2 additive with the mass ratio of 20: 1, presented high specific discharge capacities of 1356.3 and 770.2 mAh g(-1) , respectively, at scan rates of 0.1 and 5C (1C = 1675 mAh g(-1)) under conventional electrolyte dosage with electrolyte/sulfur (E/S) = 30 mL g((s))(-1). and sulfur loading of 1.1 mg cm(-2). The capacity was 1053.5 mAh g(-1) at 1C and maintained at 530.1 mAh g(-1) after 1000 cycles with the low average capacity decay rate of each cycle of 0.049%. Under low electrolyte dosages of E/S = 15 and 8 mL g((s))(-1) the high capacities of 1308.0 and 1230.4 mAh g(-1) could be still obtained at 0.1C, respectively. When the sulfur loading was increased to 2.8 mg cm(-2) and E/S was reduced to 10 mL g((s))(-1), the good capacity of 1163.6 mAh g(-1) was gotten at 0.1C. The high capacity and high cyclic property under different E/S and sulfur loading amounts indicate the potential for practical application of this simple but effective modified sulfur cathode. (C) 2020 Elsevier Ltd. All rights reserved.

Fe 2 O 3 /rGO/CNT composite sulfur hosts with physical and chemical dual-encapsulation for high performance lithium–sulfur batteries

Synergistic Ternary Composite (carbon/fe3 O4 @graphene) with Hollow Microspherical and Robust Structure for Li-Ion Storage.

Porous honeycomb-like C3N4/rGO composite as host for high performance Li-S batteries

Understanding the high-performance Fe(OH)<sub>3</sub>@GO nanoarchitecture as effective sulfur hosts for the high capacity of lithium-sulfur batteries

Understanding the high-performance Fe(OH)3@GO nanoarchitecture as effective sulfur hosts for the high capacity of lithium-sulfur batteries

A MnO2/Graphene Oxide/Multi-Walled Carbon Nanotubes-Sulfur Composite with Dual-Efficient Polysulfide Adsorption for Improving Lithium-Sulfur Batteries

A MnO 2 /Graphene Oxide/Multi-Walled Carbon Nanotubes-Sulfur Composite with Dual-Efficient Polysulfide Adsorption for Improving Lithium-Sulfur Batteries.

CuCo2S4 Nanoparticles Embedded in Carbon Nanotube Networks as Sulfur Hosts for High Performance Lithium-Sulfur Batteries

Decorating CoSe 2 Hollow Nanospheres on Reduced Graphene Oxide As Advanced Sulfur Host Material for Performance Enhanced Lithium-Sulfur Batteries

Synthesis of CoO Nanocrystals Decorated Porous Carbon Nanotube Microspheres As Sulfur Host for High Performance Li/S Batteries.

Graphene/Heterojunction Composite Prepared by Carbon Thermal Reduction as a Sulfur Host for Lithium-Sulfur Batteries

Co9S8 nanotube wrapped with graphene oxide as sulfur hosts with ultra-high sulfur content for lithium-sulfur battery

A Rgo–cnt Aerogel Covalently Bonded with a Nitrogen-Rich Polymer As a Polysulfide Adsorptive Cathode for High Sulfur Loading Lithium Sulfur Batteries

A Rgo-Based Fe2O3 and Mn3O4 Binary Crystals Nanocomposite Additive for High Performance Li–S Battery

Covalent organic framework wrapped by graphene oxide as an efficient sulfur host for high performance lithium–sulfur batteries

Densely Integrated Co, N-Codoped Graphene@Carbon Nanotube Porous Hybrids for High-Performance Lithium-Sulfur Batteries

Facile Synthesis of Rgo/g-C3n4/cnt Microspheres Via an Ethanol Assisted Spray-Drying Method for High-Performance Lithium-Sulfur Batteries

CoN//Co 9 S 8 co-embedded in reduced graphene oxide as catalyst for catalytic conversion of polysulfides

Composites of Reduced Graphene Oxide and Fe 2 O 3 Nanoparticles Anchored on MoS 2 Nanosheets for Lithium Storage

Co–TiO2 nanoparticles anchored in porous carbon matrix as an efficient sulfur host for lithium/sulfur batteries

S@CNT-graphene-TiN Multi-Dimensional Composites with High Sulfur Content As the High-Performance Lithium-Sulfur Battery Cathode Materials