Abstract:This work proposes a liquid-metal-based calorimetric micro-flow sensor within a polydimethylsiloxane (PDMS) chip. It can measure the flow rate of fluid in microscale channels, with a range as low as several microliters per minute. This in-chip sensor is proposed to solve the issue of detecting the flow rate in microfluidic systems. To make the sensor compatible with PDMS microfluidic chips, low-melting-point gallium-based alloy and bismuth-based (bi-based) alloy are used to make the micro heater and bi-metal thermocouples, for these alloys can be easily injected into a PDMS chip to form electrodes. To minimize heat resistance (or temperature difference) between fluid and the detecting ends of thermocouples, these ends are directly exposed to liquid in the flow channel with the help of a special reversible bonding technology. Thermocouples are connected in parallel to improve the sensor's response. A novel method to bond and electrically connect the sensor to a PCB (print circuit board) is also elaborated. Since the calorimetric flow sensor is sensitive to heating power, fluid temperature and environment cooling, a dimensionless parameter less independent of these factors is deduced from heat transfer theory, and this idea is used in result processing to offset the bad effect. Experiments with pure water show that this sensor can be used to detect flow rates, with a resolution up to 4 μl/min/mV and a range of 12 μl/min in this case, and that at different heating powers, the thermal potential results vary significantly whereas the dimensionless results nearly keep the same. Present work indicates that this sensor has the potential to be integrated into a PDMS microfluidic system and to provide accurate and stable results if a dimensionless method is used in data processing.

Development of a sensor for liquid film thickness measurements during annular flow in microchannels

Cross-sectional Phase Distribution Measurement of Slug Flow in Small Channels

Measurement System for Characterization of Gas-Liquid Two-Phase Flow in Micro-Channel

A New Sensor for the Void Fraction Measurement of Gas-Liquid Two-Phase Flow

Design of Thermal Liquid Flow Microsensor

An Interdigital Conductance Sensor for Measuring Liquid Film Thickness in Inclined Gas–Liquid Two-Phase Flow

High Sensitive Capacitive Sensing Method for Thickness Detection of the Water Film on an Insulation Surface

Liquid film parameter measurement based on thermal distribution sensor in horizontal annular flow

High Sensitive Flexible Hot-Film Sensor for Measurement of Unsteady Boundary Layer Flow

Fabrication and Static Calibration of Double-Layer Thermal Film Sensor for Fluid Wall Shear Stress Measurement

A New Method for Velocity Measurement of Gas-Liquid Two-Phase Flow Based on C~4D Technique

Development of Wearable Tactile Sensor Based on Galinstan Liquid Metal for Both Temperature and Contact Force Sensing.

Characterization of liquid film distribution and sub-flow regimes of annular flow in helically coiled tubes using ring island array sensor

Measuring liquid film thickness during downflow condensation in a minichannel

Design of instantaneous liquid film thickness measurement system for conductive or non-conductive fluid with high viscosity

Integrated membrane-free thermal flow sensor for silicon-on-glass microfluidics

Liquid film characteristics measurement based on NIR in gas–liquid vertical annular upward flow

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

A novel liquid metal sensor with three microchannels embedded in elastomer

A Flow Sensor for Liquids Based on Single-Walled Carbon Nanotube Thin Films

A Film Bulk Acoustic Liquid Concentration Sensor Integrated with Microchannel