Abstract:In this work, a robust stand-off alpha detection method using the secondary effects of alpha radiation has been sought. Alpha particles ionise the surrounding atmosphere as they travel. Fluorescence photons produced as a consequence of this can be used to detect the source of the alpha emissions. This paper details experiments carried out to detect this fluorescence, with the focus on photons in the ultraviolet C (UVC) wavelength range (180-280 nm). A detector, UVTron R9533 (Hamamatsu, 325-6, Sunayama-cho, Naka-ku, Hamamatsu City, Shizuoka Pref., 430-8587, Japan), designed to detect the UVC emissions from flames for fire alarm purposes, was tested in various gas atmospheres with a 210Po alpha source to determine if this could provide an avenue for stand-off alpha detection. The results of the experiments show that this detector is capable of detecting alpha-induced air fluorescence in normal indoor lighting conditions, as the interference from daylight and artificial lighting is less influential on this detection system which operates below the UVA and UVB wavelength ranges (280-315 nm and 315-380 nm respectively). Assuming a standard 1 r 2 drop off in signal, the limit of detection in this configuration can be calculated to be approximately 240 mm, well beyond the range of alpha-particles in air, which indicates that this approach could have potential for stand-off alpha detection. The gas atmospheres tested produced an increase in the detector count, with xenon having the greatest effect with a measured 52% increase in the detector response in comparison to the detector response in an air atmosphere. This type of alpha detection system could be operated at a distance, where it would potentially provide a more cost effective, safer, and faster solution in comparison with traditional alpha detection methods to detect and characterise alpha contamination in nuclear decommissioning and security applications.

UVC irradiation of alpha particles tracks and empirical equation of bulk etch rate in CR-39 detector

Estimation of alpha exposure on CR-39 detector using a UV-VIS spectrophotometer

UV effect on etching parameters and activation energy of CR-39 plastic detector

Low energy alpha particles dose mapping with a combination of CR-39 detector and a high resolution flatbed scanner

Direct and indirect determination of track etch parameters after sequential UV-C exposure and etching for two swift heavy ions in PADC: Production of rocket-shaped tracks

Surface Effect of Ultraviolet Radiation on Electrochemically Etched Alpha-Particle Tracks in PADC

Energy Calibration of a CR-39 Nuclear-Track Detector Irradiated by Charged Particles

Effects of Storage Time and Pre-Etching Treatment of CR-39 Detectors on Their Response to Alpha Radiation Exposure

Simulation of ion track ranges in uranium oxide

Experimental Study on CR-39 Response to Alpha Particles with Different Incident Angles and Energy

Studies of chemical bonds loss and optical modifications of CR-39 caused by gamma rays

Uncertainty of an Automatic System for Counting Alpha Tracks on CR-39

Measurement of Therapeutic12c Beam in a Water Phantom Using CR-39.

Empirical Assessment of the Detection Efficiency of CR-39 at High Proton Fluence and a Compact, Proton Detector for High-Fluence Applications

Comparison of Morphological Characteristics for Alpha Tracks in CR-39 Using Different Radon Monitors

Film dosimetry for occupant exposure monitoring within Far‐UVC installations

Measurement of Three-Dimensional Track Profiles on CR-39s Based on the Photometric Stereo Method.

First Results of Using a UVTron Flame Sensor to Detect Alpha-Induced Air Fluorescence in the UVC Wavelength Range

Spectroscopic and electrical changes in Lr-115 type II nuclear track detector before and after gamma radiation

CR-39 track detector calibration with H and He beams for applications in the p- 11 B fusion reaction

A New Type VUV Detector with Plane Electrodes Deposited on a Crystalline Quartz.