Abstract:In this paper, a comprehensive hybrid K-edge/XRF densitometer (HKED) device model is constructed using MCNP simulation. After the modeling process, a systematic simulation study is conducted to analyze the physical parameters and material selection of KED and XRF. The simulation results reveal that the optimal parameters for the X-ray tube are an X-ray source voltage of 160 kV and a 1 mm Fe filter. The sample should be placed in a vial with an inner diameter of 1.4 cm and an outer diameter of 2 cm. For the KED technique, the determined main parameters are a 1.9cm Fe filter rod and an inner diameter of 0.08cm for the collimator. For the XRF technique, the determined main parameters are a 0.01cm Gd filter and an inner diameter of 0.3cm for the collimator, with a detector angle of 150°. After selecting appropriate parameters, the average calibration factor Δμ of the KED technique was found to be 3.301 cm 2 ·g -1 , with a relative standard deviation (RSD) of 3.36%. Additionally, the comparison between the simulated and calculated values of uranium concentration revealed a minimum measurement error of 0.4%. The minimum detection concentration of KED for uranium solutions is approximately 1 g/L. For plutonium solutions ranging from 0.5 to 20g/L, linear fitting of the K a1 net peak area and plutonium concentration showed a coefficient of determination (R 2 ) of 0.999. The detection limit of XRF for plutonium measurement was 2.33✕10 -4 g/L. The linear fitting coefficients ( R 2 ) of uranium concentration versus K-edge transmission rate and plutonium concentration versus K a1 net peak area for the hybrid technique in measuring uranium-plutonium mixed solutions are determined as 0.999 and 0.996, respectively, demonstrating the response relationship of the HKED device to uranium and plutonium under different concentrations.

Simulation of ion track ranges in uranium oxide

Measurement and Simulation of Ultra-Low-Energy Ion-Solid Interaction Dynamics

Simulation of Ion Irradiation of Nuclear Materials and Comparison with Experiment

Simulation of Ion Implantation into Nuclear Materials and Comparison with Experiment

Molecular Dynamics Simulations of Ion Range Profiles for Heavy Ions in Light Targets

Simulated spatial and temporal dependence of chromium concentration in pure Fe and Fe-14%Cr under high dpa ion irradiation

Atomic Simulations of U-Mo under Irradiation: A New Angular Dependent Potential

Angular Distribution and Recoil Effect for 1mev Au+ Ions Through a Si3N4 Thin Foil

Nano-beam and Nano-Target Effects in Ion Radiation.

Enrichment measurement by passive γ-ray spectrometry of uranium dioxide fuel pellets using a europium-doped, strontium iodide scintillator

Monte Carlo Simulation of Prompt Γ-Ray Spectra from Depleted Uranium under D-T Neutron Irradiation and Electron Recoil Spectra in a Liquid Scintillator Detector

An AIMD+U simulation of low-energy displacement events in UO2

Isotopic effect of oxygen on the Raman mapping of a polycrystalline uranium dioxide UO2

Molecular Dynamics Simulation of Ion Implantation into Hafnium Dioxide

Automation and optimization of stopping and range of ions in matter simulation runtime

Predicting displacement damage for ion irradiation: Origin of the overestimation of vacancy production in SRIM full-cascade calculations

Investigations of Heavy-Ion Tracks' Energy Deposition Inside Solid Media by Methods of X-Ray Spectroscopy

System Optimization Study of Hybrid K-edge/XRF Densitometer for Uranium-Plutonium Solution Measurement

Evolution of dislocation loops in irradiated α-Uranium: An atomistically-informed cluster dynamics investigation

Monitoring ion track formation using in situ RBS/c and ERDA

Atomistic Computer Simulations of Uranyl Adsorption on Hydrated Illite and Smectite Surfaces