Abstract:In this paper, a method of realizing voltage-mode (VM) non-inverting high-pass filter (HPF), band-pass filter (BPF), low-pass filter (LPF), and inverting low-pass filter (ILPF) transfer functions structure with two grounded capacitors and four resistors through an analytical synthesis method is presented. The synthesis structure of the VM biquadratic filter consists of a voltage proportional block and two voltage lossless integrators based on the use of current feedback operational amplifiers (CFOAs). It is demonstrated that the derived biquadratic filter structure can simultaneously realize VM HPF, BPF and ILPF transfer functions or VM BPF and LPF transfer functions at a high-input impedance terminal. The VM biquadratic filter can independently adjust the resonance angular frequency and quality factor. By slightly modifying the proposed biquadratic filter, a VM quadrature sinusoidal oscillator can be achieved. The proposed biquadratic filter and quadrature oscillator have been simulated by OrCAD PSpice and appropriate hardware has been implemented with AD844-type CFOAs. In order to reduce power consumption, reduce chip area, reduce costs, and improve system integration, integrated VM CFOA-based biquadratic filter circuits and quadrature oscillator circuits are very important. The proposed filter and quadrature oscillator have been further fabricated in $0.18~mu text{m}$ 1P6M CMOS process technology. The entire chip area is 0.974 mm<sup>2</sup>, including a filter chip cell and an oscillator chip cell. Under the supply voltage of ±0.9 V, the total power dissipation of the filter chip cell is 5.4 mW, and the figure-of-merit (FOM) of filter chip cell is 66.7%. The measured value of the third-order intermodulation distortion of the filter chip cell is −55.29 dBc and the third-order intercept point is 19.9 dBm. The measured phase noise of -FOA-based filter chip cell at 1 kHz offset is less than −99.76 dBc/Hz.

Analysis of super‐source‐follower‐based GHz‐bandwidth biquadratic low‐pass filters

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

0.8/2.2-Ghz Programmable Active Bandpass Filters in InP/Si BiCMOS Technology

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

Design of a Miniaturized Dual-Band Double-Folded Substrate Integrated Waveguide Bandpass Filter with Controllable Bandwidths

A 0.6mw 31mhz 4Th-Order Low-Pass Filter with +29dbm IIP3 Using Self-Coupled Source Follower Based Biquads in 0.18µm CMOS

0.07mm 2, 2mW, 75MHz-IF, fourth-order BPF using source-follower-based resonator in 90nm CMOS

Quad-Band Superconducting Bandpass Filter Using Quad-Mode Stub-Loaded Resonators With Controllable Frequencies And Bandwidths

A High-Linearity 264-Mhz Source-Follower-Based Low-Pass Filter With High-Q Second-Order Cell For Mb-Ofdm Uwb

Analytical Synthesis of High-Pass, Band-Pass and Low-Pass Biquadratic Filters and its Quadrature Oscillator Application Using Current-Feedback Operational Amplifiers

A 0.65mw 20mhz 5Th-Order Low-Pass Filter With+28.8dbm Iip3 Using Source Follower Coupling

Design of a Low-Band Wideband Superconducting Filter Using Triple-Mode Resonator

A Super-Wideband Bandpass Filter Using Quarter Wavelength Parallel Microstrip Lines and Capacitors

A 5.4-Mw 50-Mhz 29.3-Dbm-iip3 Fourth-Order Low-Pass Filter

Design of Superconducting Ultra-Wideband Filter with Wide Stopband Based on Quintuple-Mode Resonator

Cost-Efficient Cmos Rf Tunable Bandpass Filter With Active Inductor-Less Biquads

An 4 Th -Order N-path Bandpass Filter with a Tuning Range of 1-30 GHz and OOB Rejection > 30 Db in 28 Nm CMOS

A 77-dB-DR 0.65-mW 20-MHz 5th-Order Coupled Source Followers Based Low-Pass Filter

Design of Miniaturized Substrate Integrated Coaxial Line Bandpass Filters with Quarter-Wavelength Spiral Resonator