Abstract:We had previously developed a measurement method using an imaging plate (IP) to evaluate and address surface contamination caused by the release of radioactive materials during the Fukushima nuclear accident. The measurement units for the surface contamination density were in relative values [described as relative luminescence levels measured in luminescence arbitrary units (LAU)], but the evaluation was required in absolute values, such as Bq cm −2 , to enable appropriate control of exposure doses. This study establishes a method for converting the IP measurements of surface contamination density due to environmental radioactivity into absolute values. Soil contaminated with radioactive materials from the Fukushima nuclear accident was collected to create a working reference material (WRM). The conversion coefficient for surface contamination density was calculated using the WRM values measured with an IP and high-purity germanium detectors. The IP measurement values were converted into the surface contamination density using the conversion coefficient. The WRM values measured with the IP and high-purity germanium detectors were 324.1 LAU and 32.22 ± 2.27 Bq cm −2 , respectively. The surface contamination density conversion factor was calculated as 0.0994. The surface contamination density on the roof of the Tsukuba City facility was re-evaluated using the conversion factor. The average value of 29,972 Bq m −2 matched the amount of radioactive material fallen in Tsukuba City. By standardizing the measurement conditions for surface contamination when using IPs, we successfully quantified the surface contamination density with an accuracy comparable to that of conventional methods. This method is expected to make a significant contribution to efficient radiation safety management.

Absolute dose rate measurement of very soft and weak x-rays by means of a GM-counter.

New Simple Measuring Method of Intensity of Pulsed Nuclear Radiation by Counting Delayed-Pulses Produced in GM Counter

Design of a Measurement Unit for Measuring the Neutron, Gamma Dose Equivalent Meanwhile Based on Single-sphere Multi-detector Neutron Spectrometer and GM Counter

GM Tube Radiation Detector based on Time - to - Count Method

Optimization of Energy Compensation Layered Structure of Geiger- Müller Counters

Experimental Investigation on Range Extension of GM Tube by Time-to-Count Method

Absolute Method for Measuring Environmental Radioactive Materials Using Imaging Plates

Development of a light-weight portable neutron survey meter

The Research on Neutron Dose Equivalent Meter for Pulse Neutron Radiation Field

Development of a high energy resolution and wide dose rate range portable gamma-ray spectrometer

A Modified Neutron Dose-Equivalent Meter for Pulsed Neutron Radiation Field

Measurements of Thoron Concentration by Passive Cup Method and Its Application to Dose Assessment

Experimental verification of real-time gamma-ray energy spectrum and dose monitor

Multi-pixel photon counter-based gamma camera with pinhole collimator to locate Cs-137 sources at high dose rates for the Fukushima nuclear power plant

Improved measurements of neutron dose equivalent rates using a dual instrument technique

Development and characterization of a dedicated dose monitor for ultrahigh-dose-rate scanned carbon-ion beams

Comparison of Monte Carlo tally techniques for dosimetry in a transmission-type x-ray tube

Establishment of pulsed X-ray reference radiation field and measurement of related parameters

Measurement Technique of Dose Rate Distribution of Ionization Sources with Unstable in Time Beam Parameters

Basic study on evaluation of X-ray dose distribution using plastic scintillator plate and digital CMOS camera

Design and performance study of a proportional counter for low-energy X-rays