Abstract:The ultimate load-carrying capacity of concrete-filled steel tubular (CFST) columns exposed to monotonic loadings can be greatly increased by strengthening those columns, and the occurrence of the steel tube's outward buckling can be postponed. The current research aims to study the possibility of improving the structural characteristics of CFST columns exposed to cyclic loadings in terms of lateral load capacity and absorbed energy by strengthening them with different patterns of fiber-reinforced polymer (FRP) sheets. The ABAQUS software was used to create a three-dimensional (3D) non-linear finite element model (FEM) to simulate the behavior of FRP-strengthened CFST columns exposed to monotonic and cyclic loadings. After ascertaining the accuracy of the proposed model's results in successfully predicting failure patterns and lateral loads compared to the experimental results of tested specimens available in the literature, the model was used to create a parametric study. The parametric study focused on the impacts of the thickness, location, and length of the strengthening sheets on the failure pattern, lateral load-carrying capacity, stiffness, cumulative energy, absorbed energy, and viscous damping factor of the CFST columns exposed to cyclic loadings. The results revealed that the un-strengthened specimen displayed a maximum lateral load of 185 kN and a viscous damping factor of 45.2% at a lateral drift of 5.7%. On the other hand, strengthening the CFST column using five layers of FRP sheets exhibited the highest lateral load of all investigated columns (50% more than the un-strengthened specimen). Additionally, at a lateral drift of 5.7%, the decrease in viscous damping factor of CFST specimens due to strengthening using 1, 2, 3, 4, and 5 layers of FRP sheets with respect to the control specimen was 7.9%, 14.9%, 20.8%, 27.7%, and 30.3%, respectively.

Life-cycle analysis of FRP-strengthened offshore CFST columns suffering from steel corrosion

Research on CFRP confined circular concrete-filled steel tubular columns subjected to cyclic lateral forces

Performance and strength calculation of CFST columns with localized pitting corrosion damage

Axial Compressive Behavior of FRP-confined Square CFST Columns Reinforced with Internal Latticed Steel Angles for Marine Structures

Analysis of CFRP-confined CFST Columns Reinforced with Steel Angles under Axial Compression

CFRP Strengthened RC Beams with Pre-Strengthening Non-Uniform Reinforcement Corrosion Subjected to Post-Strengthening Wetting/drying Cycles

Life-cycle performance of deteriorated concrete-filled steel tubular (CFST) structures subject to lateral impact

Behavior of Cfdst Stub Columns under Preload, Sustained Load and Chloride Corrosion

Experimental Investigation of a Novel CFRP-Steel Composite Tube-Confined Seawater-Sea Sand Concrete Intermediate Long Column

Behavior of Corroded Thin-Walled Concrete-Filled Steel Tubular Stub Columns

Numerical Response of Concrete-Filled Steel Tubular (CFST) Columns Externally Strengthened with FRP Composites Subjected to Cyclic Loading

Effect Of Corroded Surface Morphology On Ultra-Low Cycle Fatigue Of Steel Bridge Piers

Performance degradation of circular thin-walled CFST stub columns in high-latitude offshore region

Compressive performance of concrete-filled steel tube columns with in-built seawater and sea sand concrete-filled FRP tubes

Axial-flexural Performance of Columns Reinforced by Steel-Frp Composite Bars and FRP Ties

Compressive behavior degradation of FRP-confined RC columns exposed to a chlorine environment

Axial Compressive Behavior and Model Assessment of FRP-confined Seawater Sea-sand Concrete-Filled Stainless Steel Tubular Stub Columns

Cyclic Axial Compression Behavior of FRP-Confined Seawater Sea-Sand Concrete-Filled Stainless Steel Tube Stub Columns

Experimental study on concrete-filled steel tube columns with inner distributed seawater and sea sand concrete-filled fiber-reinforced polymer tubes under axial compression

Concrete-filled steel tubes subjected to axial compression: Life-cycle based performance

Numerical Study and Seismic Design of Corroded Circular RC Columns Strengthened by C-FRCM