Abstract:In ITER, pellets are calculated to require more than 8 times the mass than currently planned to reliably trigger ELMs. Unmitigated heat flux impulses from edge-localized modes (ELMs) are intolerable in ITER at full power and current. Therefore, ITER operation relies on multiple approaches to control ELM heat fluxes. One method is pellet ELM pacing to instigate small rapid ELMs with low heat flux. Predicting the performance of pellet pacing is critical for ITER, which is expected to operate in a regime with a low-collisionality, peeling-limited pedestal. However, to trigger ELMs the local pressure increase in the expanding pellet cloud pushes the equilibrium over the ballooning stability limit. In this work, linear and nonlinear M3D-C1 simulations are used to predict pellet mass thresholds in DIII-D discharges and ITER scenarios with peeling-limited pedestals. It is found that the distance of the equilibrium's operational point from the ballooning branch of the pedestal stability boundary strongly changes thresholds. Linear M3D-C1 simulations find a strong dependence of the pellet mass threshold on the poloidal injection location for ITER's 15 MA, Q=10 scenario. The required pellet mass at the planned injection locations is 8 to 17 times larger than currently considered. However, such linear simulations do not include pellet ablation physics or time evolution of density and temperature. A new scheme of 2D nonlinear simulations, coupled with linear stability analysis at various steps throughout the nonlinear time evolution, was developed to include such physics and improve on the linear results. These new nonlinear-to-linear simulations confirm previous findings. This result suggests that pellet ELM triggering in ITER could require pellets much larger than those currently planned, which makes ELM-pacing operationally challenging. On the other hand, fueling pellets injected from the high-field side will likely not unintentionally trigger ELMs in an otherwise ELM-stable plasma.

Drift of ablated material after pellet injection in a tokamak

Lagrangian particle model for 3D simulation of pellets and SPI fragments in tokamaks

Numerical Simulation of E×B Drift Effects on Fueling Pellet Ablation and Transport in EAST

Simulation of Deuterium Pellet Ablation and Deposition in the EAST Tokamak with HPI2 Code

3D MHD modelling of plasmoid drift following massive material injection in a tokamak

Dispersive shell pellet injection modeling and validation for DIII-D disruption mitigation

Simulation study of deuterium pellet ablation and deposition in the EAST tokamak with HPI2 code

Pellet Source Density in Toroidal Plasma Configurations Based on a 2D Gaussian Deposition Model

Near-field simulations of pellet ablation for disruptions mitigation in tokamaks

The pellet rocket effect in magnetic confinement fusion plasmas

The effect of plasmoid drifts on the pellet rocket effect in magnetic confinement fusion plasmas

Effect of Two-Stage Shattered Pellet Injection on Tokamak Disruptions

Runaway dynamics in the DT phase of ITER operations in the presence of massive material injection

Non-linear shattered pellet injection modelling in ASDEX Upgrade

Runaway electron dynamics in ITER disruptions with shattered pellet injections

Numerical Simulation of Li Pellet Ablation in the H-mode Pedestal Region

Post-Thermal Quench Shattered Pellet Injection for small Runaway Electron seed depletion in ITER

Analytical Formula for Pellet Fuel Source Density in Toroidal Plasma Configurations Based on an Areal Deposition Model

Multiple-isotope pellet cycles captured by turbulent transport modelling in the JET tokamak

Prediction of pellet mass thresholds for ELM triggering in low-collisionality, ITER-like discharges