Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

D. Hu,F. J. Artola,E. Nardon,M. Lehnen,M. Kong,D. Bonfiglio,M. Hoelzl,G.T.A. Huijsmans,JOREK Team

DOI: https://doi.org/10.1088/1741-4326/ad53e1

2024-06-07

Abstract:The heat flux mitigation during the Thermal Quench (TQ) by the Shattered Pellet Injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma, and is ultimately checked by the heat deposition on to the PFCs. To investigate this, JOREK simulations of neon-mixed dual-SPIs into ITER baseline H-mode and a "degraded H-mode" with and without good injector synchronization are performed with focus on the first wall heat flux and its energy impact. It is found that low neon fraction SPIs into the baseline H-mode plasmas exhibit strong major radial plasmoid drift as the fragments arrive at the pedestal, accompanied by edge stochasticity. Significant density expulsion and outgoing heat flux occurs as a result, reducing the mitigation efficiency. Such drift motion could be mitigated by injecting higher neon fraction pellets', or by considering the pre-disruption confinement degradation, thus improving the radiation fraction. The radiation heat flux is found to peak in the vicinity of the fragment injection location in the early injection phase, while it relaxes later on due to parallel impurity transport. The overall radiation asymmetry could be significantly mitigated by good synchronization. Time integration of the local heat flux is carried out to provide its energy impact for wall heat damage assessment. For the baseline H-mode case with full pellet injection, melting of the stainless steel of the diagnostic port could occur near the injection port, which is acceptable, without any melting of the first wall tungsten tiles. For the degraded H-mode cases with quarter-pellet SPIs, which have 1/4 total volume of a full pellet, the maximum energy impact approaches the tolerable limit of the stainless steel with un-synchronized SPIs, and stays well below such limit for the perfectly synchronized ones.

Plasma Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to mitigate the heat deposition problem on the first wall during the thermal quench (TQ) process by using the double - SPI (shattered pellet injection) technique in the ITER (International Thermonuclear Experimental Reactor) H - mode. Specifically, the research focuses on the impact of heat deposition on plasma - facing components (PFCs) under different SPI configurations (such as full pellets and quarter pellets, and injections in different synchronization states), especially on the heat flux of the first wall and its energy impact. Through JOREK simulations, the research explores the heat deposition behavior under different conditions (such as the baseline H - mode and the degraded H - mode), aiming to evaluate the efficiency of SPI in thermal quench mitigation and verify the heat - resistant specifications of ITER PFCs.

The main objectives of the paper are:
1. **Evaluate heat deposition**: Through JOREK simulations, study the heat deposition behavior under different SPI configurations, especially the heat flux on the first wall and its cumulative energy impact.
2. **Optimize SPI parameters**: Explore how to improve the uniformity of heat deposition and reduce locally excessive heat loads by adjusting SPI parameters (such as the neon gas mixing ratio, injection synchronism, etc.), thereby increasing the efficiency of thermal quench mitigation.
3. **Verify PFCs heat resistance**: Based on the simulation results, evaluate the heat - resistant properties of the first - wall materials (such as stainless steel and tungsten) under different SPI configurations to ensure that no unacceptable material damage is caused by heat deposition during actual operation.

Through these studies, the paper hopes to provide scientific basis and technical support for ITER's thermal quench mitigation strategy, ensuring that plasma - facing components can be effectively protected during actual operation and avoiding material damage caused by heat deposition.