Abstract:The species transport, electrochemical reaction, and the mechanical stress caused by water phase-change within the proton exchange membrane fuel cell have combined effect on the cold start performance. It is necessary to investigate the cold start process of the fuel cells with different flow fields, aiming to provide theoretical basis for improving cold start performance. Based on the cathode side models of fuel cells with single-channeled straight flow field, single-channeled serpentine flow field, and triple-channeled serpentine flow field at −20 °C, the electrochemical reaction and dynamic response in these fuel cells are considered to study the failed cold-start process in this paper. Then the homomorphic volume comparison method is used to analyze the cold start process of the fuel cells with different flow fields. It is found that when the average volume fraction of ice within the porous layer reaches 0.13, the maximal ice content of the porous layer is 0.493 under the inlet of the fuel cell with the single-serpentine channel, which causes the minimal stress acting on the porous layer among the three flow fields. However, the structure of the single-channeled serpentine flow field increases the pressure loss during the species transport, and the pressure drop in the flow field exceeds 347 Pa. Thus, although the single-channeled serpentine flow field has the best start-up performance among the three flow fields, the distance between the inlet and outlet of the channel can be reduced by increasing the number of channels to decrease the additional power during the cold start.

Numerical study on the influence of waveform channel and related design parameters on the cold start of proton exchange membrane fuel cell

Numerical studies of cold-start phenomenon in PEM fuel cells

A Pem Fuel Cell Model for Cold-Start Simulations

Theoretical analysis on cold start process of proton exchange membrane fuel cell with different flow fields based on the coupling of redox reaction and dynamic response of porous materials

Numerical Studies of Cold-Start Phenomena in PEM Fuel Cells: A Review

Numerical analyses of non-isothermal self-start behaviors of PEM fuel cells from subfreezing startup temperatures

Research on Water and Heat Management in the Cold Start Process of Proton Exchange Membrane Fuel Cell with Expanded Graphite Bipolar Plate

Cold Start Mode Classification Based on the Water State for Proton Exchange Membrane Fuel Cells

Numerical Simulation of the Cold-Start Process of Polymer Electrolyte Fuel Cell

Study on internal dynamic response during cold start of proton exchange membrane fuel cell with parallel and serpentine flow fields

Research on Cold Start of Proton-Exchange Membrane Fuel Cells Based on Model Predictive Control

Cold start optimization of the proton-exchange membrane fuel cell by penetrating holes in the cathode micro-diffusion layer

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

Numerical Investigation of Cold-Start Behavior of Polymer Electrolyte Fuel Cells in the Presence of Super-Cooled Water

Optimization of fast cold start strategy for PEM fuel cell stack

Study on the temperature distribution and its effect on self-start of large-area proton exchange membrane fuel cells at subzero temperatures

Effect of gas crossover on the cold start process of proton exchange membrane fuel cells

Study on Fast Cold Start-Up Method of Proton Exchange Membrane Fuel Cell Based on Electric Heating Technology

Characteristics of Cold Start Behavior of PEM Fuel Cell with Metal Foam as Cathode Flow Field under Subfreezing Temperature

Effects of porous properties on cold-start behavior of polymer electrolyte fuel cells from sub-zero to normal operating temperatures

Research on Performance of Cold Start Air Preheating System for Fuel Cell Engine