Abstract:Kraft lignin grafted with hydrophilic polymers has been prepared using reversible addition-fragmentation chain-transfer (RAFT) polymerization and investigated for use as a surfactant. In this preliminary study, polyacrylamide and poly(acrylic acid) were grafted from a lignin RAFT macroinitiator at average initiator site densities estimated to be 2 per particle and 17 per particle. The target degrees of polymerization were 50 and 100, but analysis of cleaved polyacrylamide was consistent with a higher average molecular weight, suggesting not all sites were able to participate in the polymerization. All materials were readily soluble in water, and dynamic light scattering data indicate polymer-grafted lignin coexisted in isolated and aggregated forms in aqueous media. The characteristic size was 15-20 nm at low concentrations, and aggregation appeared to be a stronger function of degree of polymerization than graft density. These species were surface active, reducing the surface tension to as low as 60 dyn/cm at 1 mg/mL, and a greater decrease was observed than for polymer-grafted silica nanoparticles, suggesting that the lignin core was also surface active. While these lignin surfactants were soluble in water, they were not soluble in hexanes. Thus, it was unexpected that water-in-oil emulsions formed in all surfactant compositions and solvent ratios tested, with average droplet sizes of 10-20 μm. However, although polymer-grafted lignin has structural features similar to nanoparticles used in Pickering emulsions, its interfacial behavior was qualitatively different. While at air-water interfaces, the hydrophilic grafts promote effective reductions in surface tension, we hypothesize that the low grafting density in these lignin surfactants favors partitioning into the hexanes side of the oil-water interface because collapsed conformations of the polymer grafts improve interfacial coverage and reduce water-hexanes interactions. We propose that polymer-grafted lignin surfactants can be considered as random patchy nanoparticles with mixed hydrophilic and hydrophobic domains that result in unexpected interfacial behaviors. Further studies are necessary to clarify the molecular basis of these phenomena, but grafting of hydrophilic polymers from kraft lignin via radical polymerization could expand the use of this important biopolymer in a broad range of surfactant applications.

Solvent‐free grafting route to develop thin and flexible polymer film from lignin

Functionalization and Thereafter Grafting with Lactic Acid to Synthesize Lignin-polylactic Acid Copolymer for Thin Film Preparation

In Situ GRAFT COPOLYMERIZATION OF STARCH WITH LACTIC ACID

Chemical modification of lignin and thereafter grafting with lactic acid for flexible polymer film preparation

Synthesization and Characterization of Lignin-graft-Poly (Lauryl Methacrylate) via ARGET ATRP

Polymer-grafted lignin surfactants prepared via reversible addition-fragmentation chain-transfer polymerization

Grafting Lignin with Bioderived Polyacrylates for Low-Cost, Ductile, and Fully Biobased Poly(lactic Acid) Composites

Strong and ultrafast stimulus-healable lignin-based composite elastomers with excellent adhesion properties

Esterification of Lignin Isolated by Deep Eutectic Solvent Using Fatty Acid Chloride, and Its Composite Film with Poly(lactic acid)

Graft Polymerization of Acrylic Monomers Onto Lignin with CaCl2–H2O2 As Initiator: Preparation, Mechanism, Characterization, and Application in Poly(lactic Acid)

Elucidating intermolecular forces to improve compatibility of kraft lignin in poly(lactic acid)

Amphiphilic Lignin Nanoparticles Made from Lignin-Acrylic Acid-Methyl Methacrylate Copolymers

Grafting of lignin onto nanostructured silica SBA-15: preparation and characterization

Enzymatic synthesis of kraft lignin-acrylate copolymers using an alkaline tolerant laccase

Multifunctional lignin-poly (lactic acid) biocomposites for packaging applications

Improved Performance of Polylactic Acid Biocomposites at High Lignin Loadings through Glycidyl Methacrylate Grafting of Melt-Flowable Organosolv Lignin

Hydrothermal method-assisted synthesis of self-crosslinked all-lignin-based hydrogels

Fabrication of modified lignin-based liquid mulching film and its potential application

Synthesis Of Lignin-G-Mma And Its Utilization In Pvc/Wood Composite

Influence of functionalised lignin on strength and antioxidant properties of polylactic acid films

Synthesis and Characterization of Poly(lactic acid) Composites with Organosolv Lignin