Abstract:A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .

A Wideband Vector-Modulated Variable Gain Phase Shifter for 5G NR FR2 in 40-nm CMOS

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A Calibration Scheme for 24–28-Ghz Variable-Gain Phase Shifter in 65-Nm CMOS

An Ultra Broadband Passive Vector Modulator Phase Shifter

An E-band Subradix Active Phase Shifter with < 0.69° RMS Phase Error and 16-Db Attenuation in 28-Nm CMOS

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A 60-GHz Variable Gain Phase Shifter With 14.8-dB Gain Tuning Range and 6-Bit Phase Resolution Across −25 °C–110 °C

29-/35 GHz Dual-band High-Gain Phase Shifter with Hybrid -Networks

A Continuous K-Band Phase Shifter Based on Injection-Locked Dual Voltage-Controlled Oscillators

A 22-to-37.8-ghz Low-Gain-Phase-Error Variable-Gain Amplifier with Impedance-Compensation Technique in 65-Nm CMOS Process

A Ka -Band CMOS Phase-Invariant and Ultralow Gain Error Variable Gain Amplifier With Active Cross-Coupling Neutralization and Asymmetric Capacitor Techniques

A Digitally-Controlled Bidirectional 24-32 GHz Variable Gain Phase Shifter in 45 nm SOI CMOS

A 20 ~ 43 GHz VGA with 21.5 Db Gain Tuning Range and Low Phase Variation for 5G Communications in 65-Nm CMOS

A Variable Gain Phase Shifter Based on Insertion-Loss-Tunable Baluns

A 20–43-GHz Low Phase Variation VGA With Feedforward Signal Suppression and Impedance-Invariant Techniques in 65-nm CMOS

A 6-Bit 38 GHz SiGe BiCMOS Phase Shifter for 5G Phased Array Communications.

A 21 to 30-Ghz Merged Digital-Controlled High Resolution Phase Shifter-Programmable Gain Amplifier with Orthogonal Phase and Gain Control for 5-G Phase Array Application

A 22.5–33.5-Ghz Hybrid Phase Shifter with Low Phase and Amplitude Error for 5G and Satellite Communication

A $W$-Band 0.18-Db RMS Gain and 0.97$^{\circ}$ Phase Error Active Phase Shifter in 28-Nm CMOS

A 220–320-GHz Vector-Sum Phase Shifter Using Single Gilbert-Cell Structure With Lossy Output Matching