High Temperature Fatigue of Additively Manufactured Inconel 718: A Short Review
Samuel Alfred,Mehdi Amiri
DOI: https://doi.org/10.1115/1.4066048
2024-07-23
Journal of Engineering Materials and Technology
Abstract:Abstract With the increasing interest in adopting additively manufactured (AM) IN718 for high-temperature applications, driven by the design and manufacturing flexibility offered by AM technologies, understanding its fatigue performance is crucial before full-scale adoption. This paper reviews the recent literature on the high-temperature fatigue behavior of AM IN718. The review focuses on two primary stages of fatigue damage: fatigue crack initiation and fatigue crack growth. Notably, most existing studies have concentrated on fatigue crack initiation, and thus, this review emphasizes this aspect. In the fatigue crack initiation stage, discrepancies in low cycle fatigue (LCF) and high cycle fatigue (HCF) life performances are observed in the literature. Some studies have shown that the average room temperature (RT) fatigue life of AM IN718 is superior or comparable to that at high temperatures in the LCF regime. Conversely, in the HCF regime, high-temperature fatigue life is sometimes found to be superior to that at room temperature. However, other studies indicate no clear trend regarding the effect of temperature on HCF life. Although various mechanisms have been proposed to either improve or degrade fatigue performance across the LCF, HCF, and very high cycle fatigue (VHCF) regimes, the underlying reasons for the distinct behaviors in these regimes remain unclear. Competing mechanisms, such as surface oxide formation and thermally driven dislocations glide, can potentially enhance or reduce fatigue life. However, the interaction and control of these mechanisms over the fatigue strength of AM IN718 are not yet fully understood. Systematic studies are required to elucidate their roles in high-temperature fatigue. Microstructural investigations have suggested that controlling the formation and precipitation of deleterious secondary phases is crucial for tailoring the high-temperature fatigue strength of AM IN718. Therefore, it is imperative to design heat treatment protocols informed by a comprehensive understanding of phase formation kinetics to improve the high-temperature fatigue performance of AM IN718 compared to their traditionally manufactured (TM) counterparts. This is particularly important for IN718 parts manufactured using directed energy deposition technology, which currently lacks standardized heat treatment procedures. The review also identifies open research areas and provides recommendations for future work to address these gaps.
materials science, multidisciplinary,engineering, mechanical