Abstract:Abstract In order to enhance competitiveness of rigid risers for the Brazilian pre-salt, great effort has been devoted to study the feasibility of Steel Catenary Risers (SCR) directly connected to Floating Production Storage and Offloading (FPSO) units, where cost savings are expected from the reduction of pipe buoyance modules and overall piping length. A recent paper presented the technical feasibility of Damped SCR, which is a new SCR concept. In that study, some non-field-proven fatigue performance improvements were required, such as girth welds for mechanically lined pipe (MLP) with increased fatigue strength and/or upset end pipes. During the development of this technology, a fracture mechanics approach became essential for the assessment of fatigue and fracture limit state in order to guarantee that the risks associated with fabrication and inspection are within acceptable safety levels. This paper presents the main issues related to fabrication and inspection activities with a particular focus on the smallest critical flaw size. A semi-deterministic Engineering Critical Assessment (ECA) was performed as part of the conceptual design. The uncertainties about input data are discussed and a simplified procedure is proposed. Results are compared with relevant non-destructive testing reliability statistics. This study indicates that the benefits obtained from the use of materials with superior fatigue resistance are limited to the non-destructive testing reliability at some degree. As the proposed methodology deals with uncertainty in input data, a roadmap for the development of a full probabilistic risk assessment of fabrication and inspection feasibility at early design stages is devised.

Defect assessment of steel catenary risers considering welding residual stress

IMPROVED EMPIRICAL FORMULATION FOR SEABED TRENCH PROFILE AT TOUCHDOWN ZONE AND ITS EFFECTS ON FATIGUE OF STEEL CATENARY RISERS

A Fracture Mechanics-Based Feasibility Study of Damped Steel Catenary Risers for Pre-Salt Field Developments

Fatigue analysis of a steel catenary riser at touchdown zone with seabed resistance and hydrodynamic forces

Residual Stress Study of High Manganese Steel Riser Pipe Manufactured by Longitudinal Butt Welding (2) : Equation for Predicting Welding Induced Residual Stresses Established through Parametric Study

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Dynamic analysis of steel catenary riser on the nonlinear seabed using vector form intrinsic finite element method

Analysis of Crack Propagation Behaviors in RPV Dissimilar Metal Welded Joints Affected by Residual Stress

Effect of Welding Defects on Fatigue Properties of SWA490BW Steel Cruciform Welded Joints

Effect of welding residual stress on the performance of CFST tubular joints

Numerical simulation of distortion-induced fatigue crack growth using extended finite element method

Influence of seabed trench on the structural behavior of steel catenary riser using the vector form intrinsic finite element method

Investigation on residual stress of EQ56 high strength steel butt weld

Study on Stress Intensity Factor of Girth Weld with Crack Defects

Fatigue analysis of steel catenary risers under coupled cross-flow and in-line vortex-induced vibrations with oblique incoming flow

Analysis of Crack Propagation of Annular Butt Weld and Distribution of Weld-Induced Residual Stress

Improved empirical formulation for seabed trench and its influence on fatigue performance of steel catenary risers under directional waves and currents

Cyclic elastoplasticity-based life assessment of fatigue crack initiation and subsequent propagation in rib-to-deck welded joints

Experimental investigation and numerical simulation on welding residual stress of innovative double-side welded rib-to-deck joints of orthotropic steel decks

Fatigue testing strategies for the X65 steel catenary riser with small‐scale specimens considering the effect of welding residual stress

XFEM based study on fatigue performance of rib-to-diaphragm welded joints considering initial defects