Abstract:The accurate geometry and effective control during the ring rolling process are the prerequisites for the ring products’ precise forming. In this paper, the interaction modes and rules between ring and rolls in vertical hot ring rolling (VHRR) process are analyzed, and the change laws of the ring’s geometry are studied. Based on the ABAQUS/Explicit software and its subroutine VUAMP, the finite element (FE) model of the VHRR process with measurement and control is established. Then, the ring rolling process of a groove-section profile ring is simulated. During the simulation, the ring’s outer diameter, roundness error, and the stability of the rolling process are detected in time, and the close-loop control of feed plan of the drive roll and measuring roll are also employed. The results obtained show the following: (1) Four feed stages are divided by means of a step-down feed movement, that is, bite stage, main rolling stage, precise forming stage, and sizing stage. (2) At bite and main rolling stages of the VHRR process, the ring’s center swings in a spiral line, and the rolling process is unstable, the ring’s roundness becomes worse, while the process is entering the precise forming stage, by means of the guide roll, the rolling process becomes steady and the ring’s roundness tends to be better. (3) The measuring roll contacts with the ring at the main rolling stage, afterwards, it is pushed back at the precise forming stage by ring’s growth. When the measuring roll meets the desired displacement value, a stop feeding command will be fed back, and the ring rolling process enters the sizing stage. At the sizing stage, the ring’s outer diameter still increases a little. (4) A series of VHRR experiments are conducted, and FE results are in good agreement with experimental results. The absolute errors of the ring’s outer diameter and the roundness are within 1 mm. The research results of this paper have practical significance to guide the VHRR production.

Study on roll shape control characteristics of electromagnetic control sleeve support roll

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Analysis of the influence of roll size change on electromagnetic heat conversion capacity and roll profile control characteristics in the RPECT

Shape and Crown Control Strategy for PC Mill

Analysis on shape control performance of cold tandem mill with ESS roll profile

Research on an external adjustment method for RPECT roll profiles based on the segmented cooling principle

Research onForecast of Roll Wear of PC Mill

Contact Behaviors for Elastic Coupling System of Back -Up Roll Grouped Bearings and Intermediate Roll of Sendzimir Mill

Design of intermediate roll contour and analysis of regulation ability on strip shape of 18-High mill

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

STUDY ON ROLL WEAR ON HOT STRIP ROLLING MILL

The production and formal control of sulphide inclusions in steel

Numerical simulation and experimental study on geometry variations and process control method of vertical hot ring rolling

Mathematical and numerical analysis of cross-directional control for SmartCrown rolls in strip mill

Finite Element Analysis of Contact Stresses on the Backup Roll of CVC Hot Rolling Mills

Research on Temperature Change Law and Non-Uniform Distribution Characteristics of Electromagnetic Control Roll Based on Rotating Heat Flow

Research on the Corner Stress of Dog-Bone Shaped Workpiece During Flat-Spread Rolling

Research on the Mechanism and Processability of Roll Forming

Experimental and Theoretical Study on Forming Film Properties of Hollow Cylindrical Rollers

Numerical Research on the Electrical Contact Model and Thermal Analysis of the Roll-Ring