Ionic liquid-induced low temperature graphitization of cellulose-derived biochar for high performance sodium storage

Yang Yu,Zhuoya Ren,Qianqian Shang,Jiangang Han,Lei Li,Jianqiang Chen,Sandile Fakudze,Ziqi Tian,Chengguo Liu

DOI: https://doi.org/10.1016/j.surfcoat.2021.127034

IF: 4.865

2021-04-01

Surface and Coatings Technology

Abstract:<p>The graphitization of biochar by high temperature carbonization above 2000 °C or metal-based catalytic approaches posed specific hindrances to the industrial production of high-quality graphitic carbon from biomass. The use of imidazolium-based ionic liquids (ILs) to induce fast graphitization of biochar at a low temperature range has not yet been reported. In this work, the carbonization of microcrystalline cellulose and 1-butyl-3-methylimidazolium acetate (BMIMAcO) at the temperature range of 750 °C–1400 °C led to enhanced graphitization of the biochar in comparison with the carbonization of microcrystalline cellulose alone. The incorporation of intact imidazolium rings into carbon skeleton played a critical role in the formation of graphitic structure with high nitrogen content. The IL-induced cellulose carbon obtained at 1000 °C (ICC-1000) with 5.67 at.% of nitrogen-doping presented interconnected graphitic nanosheets with 0.488 nm interlayer spacing and abundant mesopores and macropores on the surface. When used as anodes of sodium-ion batteries (SIBs), the ICC-1000 exhibited stable reversible capacity around 391 mAh g⁻¹ at 100 mA g⁻¹ for 100 cycles and 136 mAh g⁻¹ at 500 mA g⁻¹ for 1000 cycles, showing satisfactory sodium storage performance. Kinetic analysis of Na⁺ storage revealed that the ICC-1000 showed obvious capacitive characteristics and improved electric conductivity. DFT calculations suggested an interlayer spacing of 4.9 Å for optimal Na⁺ intercalation in multilayer graphene, and the capacity of pristine multilayer graphene was greatly improved from 69.8 to 527.3 mAh g⁻¹ after 4.8 at.% of N-doping.</p>

physics, applied,materials science, coatings & films