Abstract:Recently, sodium ion batteries (NIBs) gained increasing attention, because of its abundant reserves and relatively even geological distribution. However, the development of NIBs is greatly hampered because of the lack of appropriate active materials for both cathodes and anodes. Since the Na ion is ca. 55% larger than the Li ion, finding suitable host materials with sufficiently large interstitial space to accommodate sodium ions and to allow reversible and rapid ion insertion and extraction is very difficult. NASICON-type Na3V2(PO4)3 has recently been considered as a prospective cathode material for NIBs, because of its highly covalent 3D framework crystalline structure, high energy density (~400 Wh/kg) and good thermal stability. For anode materials, disordered carbon is particularly attractive because of their large interlayer distance and disordered structure that could accommodate sodium ions. Here, we briefly present porous carbon based electrodes for NIBs with excellent rate performance: (1) Carbon-coated nanosized Na3V2(PO4)3 embedded in the porous carbon matrix (abbreviated as CC-NVP@PCM); (2) Nitrogen-doped activated porous carbon fibers (ACFs); (3)Flexible free-standing porous carbon nanofibers (P-CNFs) with three-dimensional (3D) interconnected structure. The CC-NVP@PCM was prepared by using a facile soft-chemistry based method with post heat-treatment. It shows high rate performance (44 mAhg-1at 200C ). This ultrahigh rate performance is comparable to that of supercapacitor, but with much higher energy density. The ACFs were synthesized by pyrolysis of Ppy nanofiber precursor. It shows excellent capacity retention and extraordinary rate performance. The reversible capacity at 0.05 Ag-1 is 296 mAhg-1 and could still maintain as 72 mAg-1 at a current of 10 Ag-1. In case of the P-CNFs electrode prepared by electrospinning, it delivers a reversible capacity of 266 mAh.g-1 after 100 cycles at 0.2C, corresponding to 80.3 % of the initial charge capacity. When cycled at a current density as high as 500 mAg-1 (2C), it still delivers a reversible capacity of ~140 mAh.g-1after 1000 cycles. The improvement of electrochemical performance of these porous carbon based electrodes for NIBs is attributed to the special design and porous structure, which confined a variety of advantages: hierarchical porous channels enabling short transport length for ions and electrons, carbon coated structure resulting in low resistances, good mechanical properties leading to the excellent morphology stability.

High-temperature treatment induced carbon anode with ultrahigh Na storage capacity at low-voltage plateau

In Situ Nitrogen-Doped Helical Mesoporous Carbonaceous Nanotubes for Superior-High Lithium Anodic Performance

Disordered Carbon Anodes for Na-ion Batteries—quo Vadis?

Enhanced Silicon Diphosphide-Carbon Composite Anode for Long-Cycle, High-Efficient Sodium Ion Batteries

Double-Morphology CoS2 Anchored on N-Doped Multichannel Carbon Nanofibers As High-Performance Anode Materials for Na-Ion Batteries

Yolk-shell Structured Sb@C Anodes for High Energy Na-ion Batteries

Investigating The Superior Performance of Hard Carbon Anodes in Sodium‐Ion Compared with lithium‐ and potassium‐Ion Batteries

Electrodes for Sodium-Ion Batteries with Excellent Rate Performance Using Porous Carbon Networks

Ultrasmall MnO Nanoparticles Supported on Nitrogen-Doped Carbon Nanotubes As Efficient Anode Materials for Sodium Ion Batteries.

Hybrid-Mechanism Synergistic Flexible Nb2O5@WS2@C Carbon Nanofiber Anode for Superior Sodium Storage

Double-shell and hierarchical porous nitrogen-doped carbon nanocages as superior anode material for advanced sodium-ion batteries

Nitrogen-Doped Carbon-Confined Ni0.6Fe0.4Se2 Nanoboxes Bridged by Carbon Nanotube Networks for Efficient Sodium-Ion Batteries

Waste-to-wealth: low-cost hard carbon anode derived from unburned charcoal with high capacity and long cycle life for sodium-ion/lithium-ion batteries

Advanced Nanostructured Anode Materials For Sodium-Ion Batteries

Advanced Na-Ion Batteries Based on Porous Nanocarbon Composites and Hybrids

Nitrogen and sulfur co-doped mesoporous carbon derived from ionic liquid as high-performance anode material for sodium ion batteries

Enhancing capacitive storage of carbonaceous anode by surface doping and structural modulation for high-performance sodium-ion battery

Core–Shell Co 2 VO 4 /Carbon Composite Anode for Highly Stable and Fast-Charging Sodium-Ion Batteries

Coupled Carbonization Strategy toward Advanced Hard Carbon for High-Energy Sodium-Ion Battery

Core-Shell Co2VO4/Carbon Composite Anode for Highly Stable and Fast-Charging Sodium-Ion Batteries

Long-aspect-ratio N-rich carbon nanotubes as anode material for sodium and lithium ion batteries