3D printing of zirconia via digital light processing: optimization of slurry and debinding process

Jinxing Sun,Jon Binner,Jiaming Bai

DOI: https://doi.org/10.1016/j.jeurceramsoc.2020.05.079

IF: 5.7

2020-12-01

Journal of the European Ceramic Society

Abstract:<p>Digital light processing (DLP) is regarded as one of the most promising 3D printing technologies. The precise composition of the slurry and the optimisation of the debinding process, however, are still challenges that need to be overcome. In this work, both the dispersion and rheological behaviour of the zirconia slurry were studied using rheometery and UV-vis spectroscopy and optimising the dispersant concentration was found to have significant benefits. Zirconia green parts were fabricated with zirconia slurry based on DLP technology, which exhibited good dimensional resolution under an exposure energy dose of 15 mJ cm^-2. In addition, the debinding process was studied using TGA and an optimised approach designed and developed. Dye penetration and SEM results showed that debinding under argon, rather than under flowing air, could lead to crack-free parts at heating rates of either 0.2 or 0.5 °C min^-1, though the former yielded slightly better results overall.</p>

materials science, ceramics