Abstract:Variable valve actuation (VVA) systems based on electromechanical valve actuators (EMVAs) enable a flexible operation and management of internal combustion engines that results in a reduction of pollutant emission and fuel consumption while improving engine power and efficiency. However, to achieve the benefits promised by EMVAs, it is of utmost importance to guarantee the catch of the valve by the system magnets with an acceptable impact speed of the valve at the end‐strokes. Valve catching failures can severely damage engine valves while high impact speeds induce mechanical wear and unacceptable noise. The soft landing control of the valve at the end‐strokes is challenging because of system nonlinearities, parameter uncertainties, and external disturbances. The complexity of the control design increases further when industrial cost‐effective solutions are sought. This paper presents a novel solution for reducing the impact speed of the valve without the use of costly position valve sensors. The proposed solution leverages on a small hydraulic damper (HD) embedded into the EMVA and a feedback cycle‐by‐cycle controller. The passive element reduces the impact speed while the controller adjusts at every engine cycle the EMVA coil currents based on pressure peaks detected in the HD to guarantee valve catching while steering the impact speed toward its minimum. The design of the controller exploits a physics‐based model that maps the pressure peak in the HD onto the impact speed and a gradient descent algorithm is adopted searching the minimum. The closed‐loop permanence is assessed in simulation by using an experimentally validated EMVA model and considering detailed dynamics of the HD. Numerical results show the ability of the proposed control architecture to reduce the impact speed and its robustness to parameters variations (oil temperature) and external disturbances (gas pressure forces).

Transient Control of Electro-Hydraulic Fully Flexible Engine Valve Actuation System

Analysis of the Advantages of Electromagnetic Control Fully Variable Valve Actuation System on the Basis of Simulation

Harmonic and Synchronous Compound Control of a Dual-Valve Controlled Single-Rod Electro-Hydraulic Actuator.

Optimization of Integrated High-Speed On/Off Valve Aligned with Voltage Control Strategies for Enhanced Dynamic Performance in Digital Hydraulic Systems

Modeling and Control of Electro-hydraulic Camless Valvetrain System

Electro-hydraulic Variable Valve System for Hybrid Pneumatic-Internal Combustion Engine

A flexible, electronically controlled, hydraulically actuating variable valve system for diesel engine

Electromagnetic Valve Train for Gasoline Engine Exhaust System

Valve-based compensation for controllability improvement of the energy-saving electrohydraulic flow matching system

Modeling and Dynamic Characteristics Analysis on a Three-Stage Fast-Response and Large-Flow Directional Valve

Measurement and modelling of a linear electromagnetic actuator driven camless valve train for spark ignition IC engines under full load condition

The Design of Low Cost Valve-and-pump Compounded Pressure Control System for the Hydro Viscous Clutch

Precise motion control of an electromagnetic valve actuator with adaptive robust compensation of combustion force

A comprehensive mathematical theory and optimized design of a high-frequency electro-pneumatic variable valve actuator for a camless IC engine

Virtual design of rigidity for valve train system in internal combustion engine

Flow control of double bypass variable cycle engine in modal transition

Design and Implementation of a Linear Active Disturbance Rejection Control-Based Position Servo Control System of an Electromotive Valve for Exhaust Gas Recirculation

Experimental Study on Hydraulic Pulsation Features of Intelligent Variable Valve System for Auto Energy Saving

Modelling and cycle‐by‐cycle control of an electromechanical engine valve actuator with impact speed limiter based on hydraulic damper

Research on Engine Characteristics Based on Cyclic Mode Variable Displacement Control

Kinetic behavior evaluation of electromagnetic valve train subject to exhaust gas force