Abstract:This work studies the effect of mechanical properties and microstructure on sliding wear and cavitation erosion behaviors of cermet coatings deposited via high velocity oxy-fuel (HVOF) spraying on AZ31 magnesium substrate. Cavitation tests indicated that WC-Co-Cr cermet had superior resistance to cavitation erosion than WC-Cr 3 C 2 -Ni, WC-Co coatings, and far better resistance than the AZ31 expressed by the volume material loss 3.74 mm 3 , 6.99 mm 3 , 10.30 mm 3 , and 108.82 mm 3 , respectively. WC-Co-Cr coating's erosion mechanism exhibited uniform material removal, which slows the erosion rate. The CoCr binder prevented severe surface pitting and the detachment of the WC-Co-Cr cermet material in massive chunks which was observed for WC-Co and WC-Cr 3 C 2 -Ni coatings. Cermet coatings microstructure discontinuities such as pores and ceramic-metallic phase interfaces are the centers of material erosion. No clear correlation between the erosion behavior and mechanical properties of coatings was revealed. Contrary to that, sliding wear results were strongly related to the mechanical properties. The WC-Co-Cr and WC-Co samples exhibited higher hardness and higher values of Young's modulus than the WC-Cr 3 C 2 -Ni one. The generated stresses with lower values of hardness and Young's modulus for the WC-Cr 3 C 2 -Ni sample resulted in a higher wear factor, approx. 1·10 −7 mm 3 ·N −1 ·m −1 . For the harder samples, which exhibited higher stiffness (WC-Co-Cr and WC-Co), this type of wear resulted in lower values of the wear factor: 6·10 −8 mm 3 ·N −1 ·m −1 and 9·10 −8 mm 3 ·N −1 ·m −1 , respectively. Deposition of the cermet coatings effectively protected the magnesium substrate, which shows low resistance to cavitation erosion and sliding wear when uncoated.

Cavitation erosion resistance in NaCl medium of HVOF sprayed WC-based cermet coatings at various flow velocities: A comparative study on the effect of Ni and CoCr binder phases

Cavitation erosion characteristics at various flow velocities in NaCl medium of carbide-based cermet coatings prepared by HVOF spraying

Hydro-abrasive Erosion and Cavitation-Silt Erosion Characteristics of HVOF Sprayed WC-Ni Cermet Coatings under Different Flow Velocities and Sand Concentrations

Influences of Sand Concentration and Flow Velocity on Hydro-Abrasive Erosion Behaviors of HVOF Sprayed Cr3C2–NiCr and WC–Cr3C2–Ni Coatings

Cavitation-silt erosion behavior and mechanism in simulated sea water slurries of cermet coatings manufactured by HVOF spraying

Slurry erosion behaviour and mechanism of HVOF sprayed micro-nano structured WC-CoCr coatings in NaCl medium

Resistance of HVOF-Sprayed Cr3C2-25NiCr and WC-10CO-4Cr coatings to cavitation and erosion by mud jetting

Effects of microstructure and mechanical properties on cavitation erosion resistance of NiCrWMoCuCBFe coatings

Tribocorrosion behavior of HVOF sprayed WC-based cermet coatings in sodium chloride solution environment in relation to binder phases

Effect of 3.5 % NaCl solution with different Na 2 S concentrations on ultrasonic cavitation erosion behaviors of HVOF sprayed WC-Ni coatings

Effects Of Wc Crystal Characteristics On Microstructure And Mechanical Property Of Hvof-Sprayed Wc-Cocr Coatings

Investigations of cavitation erosion and wear resistance of cermet coatings manufactured by HVOF spraying

Performance evaluation of HVOF sprayed WC-10Co4Cr coatings under slurry erosion

Corrosive wear behavior of HVOF-sprayed micro-nano-structured Cr3C2–NiCr cermet coatings under aqueous media

Insights into the exceptional cavitation erosion resistance of laser surface melted Ni-WC composites: The effects of WC morphology and distribution

Microstructure and mechanical property of high velocity oxy-fuel sprayed WC-Cr3C2-Ni coatings

A comparative assessment on the characteristics of HVOF sprayed cermet coatings

Effect of Microstructure and Hardness on Cavitation Erosion and Dry Sliding Wear of HVOF Deposited CoNiCrAlY, NiCoCrAlY and NiCrMoNbTa Coatings

Evaluation of cavitation/corrosion synergy of the Cr3C2-25NiCr coating deposited by HVOF process

Effect of prolonged immersion on corrosion and cavitation resistance of HVOF-sprayed WC-NiCr and WC-Hastelloy cermet coatings

Erosion Resistance Of Ni-Wc Self-Fluxing Alloy Coating At High Temperature