Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Macroscopic behaviour and mesoscopic mechanism of shear strength characteristics of pile-soil interface under cyclic loading

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Pile-soil Interface Shear Characteristic Research in Offshore Wind Power Project

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Dynamic Response of Offshore Open-Ended Pile under Lateral Cyclic Loadings

Influence of Vertical Shear Stresses Due to Pile-Soil Interaction on Lateral Dynamic Responses for Offshore Monopiles

A Bounding-Surface-based Cyclic "P-Y Plus M-θ" Model for Unified Description of Laterally Loaded Piles with Different Failure Modes in Clay

Study on Cyclic Shear Properties of Siliceous Sand–Steel Interface under Different Normal Loading Conditions

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Undrained cyclic shear strength and stiffness degradation of overconsolidated soft marine clay in simple shear tests

Model Tests on Jacking Installation and Lateral Loading Performance of Jacket Foundation in Sand

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

Theoretical investigation on axial cyclic performance of monopile in sands using interface constitutive models