Abstract:At present, pumped storage is the only system to store huge amounts of energy. The surplus of energy in the electrical grid is used for pumping water from a lower to a higher reservoir (pump operation). At peak hours or in case of emergency this water goes down generating electrical energy (turbine operation). In the last years, due to the massive entrance of wind power, the number of start and stop cycles have increased dramatically as well as the operation at very low loads. In this new scenario more cases of damage have been reported and an effective vibration monitoring is necessary.Reversible pump-turbines (RPT) are high performance machines that have to change operation from pump to turbine mode (reversing runner rotation and flow direction) in a short time. Due to their special design characteristics (large power concentration) and operating conditions, they generate large pressure pulsations and forces when in operation.In this paper the vibration monitoring of large RPT units have been analysed. The results obtained after 15years of monitoring several power plants with this type of machines have been used for the analysis. In the last years, most of the supervised power plants have been monitored on-line remotely.First the monitoring system used is described. The main types of excitation forces expected during the operation of these machines are studied especially the most characteristic and distinctive that are the pressure pulsations due to the rotor/stator interaction.The vibration signatures measured in machines with different designs are analysed in detail and compared with the signatures of conventional turbines. The influence of the operation type (as a pump and or as a turbine) and on the power delivered has been studied and the changes of the signatures presented. After the analysis of the vibration signatures the procedure used for the selection of spectral bands is explained.The analysis of the results obtained with the monitoring is shown. First the evolution of overall levels and the comparison with vibration Standards is discussed. Second the main types of damage found are introduced. Damage in the generator, in bearings, in supporting structure and abnormal operation with cavitation are shown. The changes in vibration signatures and spectral bands for these types of damage are also given. Finally the specific case of damage in runners is introduced.

Condition monitoring of pump-turbines. New challenges

Analysis of Inter-blade Vortex and Runner Blades Force of Pump Turbine during Load Rejection Period

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Distribution Features of Flow Patterns and Pressure Pulsations of Pump-Turbine in Five Operating Modes on the Four-Quadrant Plane

Monitoring of Rotor-Stator Interaction in Pump-Turbine Using Vibrations Measured with On-Board Sensors Rotating with Shaft

On the use of artificial neural networks for condition monitoring of pump-turbines with extended operation

Frequencies in the Vibration Induced by the Rotor Stator Interaction in a Centrifugal Pump Turbine

Characterization of the hydrodynamic instabilities in a pump-turbine operating at part load in turbine mode

Experimental and Numerical Investigation of Rotor–Stator Interaction in a Large Prototype Pump–Turbine in Turbine Mode

Transient simulation of reversible pump turbine during pump mode's starting up

Numerical study of rotor-stator interaction in variable speed reversible pump-turbine in turbine mode at low head

Analysis of Flow and Runner Dynamic Response Characteristics under Pump Conditions of Variable-Speed Pump Turbine

Pump-turbine Rotor-Stator Interaction Induced Vibration: Problem Resolution and Experience

Rotor–stator interaction investigations in variable speed reversible pump-turbine at higher head

Pulsation Stability Analysis of a Prototype Pump-Turbine during Pump Mode Startup: Field Test Observations and Insights

Dynamic characteristic analysis of pressure pulsations of a pump turbine in turbine mode utilizing variational mode decomposition combined with Hilbert transform

Analysis of S Characteristics and Pressure Pulsations in a Pump-Turbine With Misaligned Guide Vanes

Dynamic characteristics of the rotor system for large pump-turbine sets

Dynamic Characteristic Analysis of a Pump-Turbine Unit under the High Pressure Pulsation Operating Condition - Fluid Dynamics Analysis

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions