Effects of chip breaker groove and tool nose radius on progressive tool wear and behavior when turning GH3536 nickel-based superalloys

Xiaodong Zhang,Maojun Li,Sein Leung Soo,Xujing Yang

DOI: https://doi.org/10.1016/j.triboint.2024.109806

IF: 5.62

2024-05-24

Tribology International

Abstract:Nickel-based superalloys are typically challenging to machine and often exhibit severe tool wear during the turning process, thus attracting substantial research attention. This study not only explores the tool wear mechanisms when turning GH3536 nickel-based superalloys but also introduces a focus on the role of tool geometry configuration. Tools with different chip breaker groove structures and nose radii were investigated, with results indicating the tool wear mechanisms were predominantly abrasive and adhesive. For the 04HA chip breaker, which has a 9° rake angle and a "V"-shaped bottom, there is a single point of impact with the chip during cutting, while the 04VP3 chip breaker, with a 15° rake angle and a flat bottom, has two points of impact with the chip during cutting, increasing chip deformation and favoring chip breaking, thereby suppressing the formation of built-up edge. Additionally, changes in the nose radius influenced the degree of work hardening and consequently influence the severity of notch wear, with the nose radius also impacting the chip flow angle. Based on this finding, a theoretical mathematical model describing the initial chip flow angle was established and validated. Additionally, an examination of the effects of varying operating parameters on tool life was conducted, revealing that cutting speed was the most significant factor affecting tool life, followed by feed rate and depth of cut.

engineering, mechanical