Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Thermodynamic analysis of a supercritical CO2 Brayton cycle integrated with solid oxide fuel cell

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Dynamic Performance and Control Analysis of Supercritical CO2 Brayton Cycle for Solid Oxide Fuel Cell Waste Heat Recovery

THERMODYNAMIC ANALYSIS AND SYSTEM DESIGN OF THE SUPERCRITICAL CO2 BRAYTON CYCLE FOR WASTE HEAT RECOVERY OF GAS TURBINE

Thermodynamic Analysis of Various Combined SOFC-SCO2 Brayton Cycle System Layouts

Proposal and Thermodynamic Assessment of S-CO2 Brayton Cycle Layout for Improved Heat Recovery

Design and Analysis of S-CO2 Cycle and Radial Turbine for SOFC Vehicle Waste-Heat Recovery

Thermodynamic analysis of solid oxide fuel cell & reheat and regenerative braysson cycle hybrid system integrated with steam generation

Performance of supercritical Brayton cycle using CO2-based binary mixture at varying critical points for SFR applications

Exergy and Exergoeconomic Analyses of A Supercritical Co2 Cycle for A Cogeneration Application

Thermodynamic Analysis of a Combined Recompression Supercritical Carbon Dioxide Brayton Cycle With an Organic Flash Cycle for Hybrid Solar-Geothermal Energies Power Generation

Energy Analysis of Waste Heat Recovery Using Supercritical CO2 Brayton Cycle for Series Hybrid Electric Vehicles

Performance Analysis and Parametric Optimization of Supercritical Carbon Dioxide Cycle with Bottoming Organic Rankine Cycle

Investigation on the performance of the supercritical Brayton cycle with CO2-based binary mixture as working fluid for an energy transportation system of a nuclear reactor

Off-Design Analysis of a Supercritical CO2 Brayton Cycle with Ambient Air As the Cold Source Driven by Waste Heat from Gas Turbine

Performance Improvement Overview of the Supercritical Carbon Dioxide Brayton Cycle

Improved Design of Supercritical CO2 Brayton Cycle for Coal-Fired Power Plant

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

An adaptive CO 2 Brayton-Rankine power cycle for efficient utilization of low environment temperature: A thermodynamic analysis and optimization study

Performance Analysis of Heat Exchangers and Integrated Supercritical CO2 Brayton Cycle for Varying Heat Carrier, Cooling and Working Fluid Flow Rates

Process Synthesis of an S-CO2Brayton Cycle Operating at an Ultra-Supercritical Steam Cycle Level