Abstract:The liquid-phase exfoliation (LPE) of black phosphorus (BP) is a strategic route for the large-scale production of phosphorene and few-layer BP (FL-BP) flakes. The exploitation of this exfoliated material in cutting-edge technologies, e.g., in flexible electronics and energy storage, is however limited by the fact that the LPE of BP is usually carried out at a high boiling point and in toxic solvents. In fact, the solvent residual is detrimental to device performance in real applications; thus, complete solvent removal is critical. Here, we tackle these issues by exfoliating BP in different low boiling-point solvents. Among these solvents, we find that acetone also provides a high concentration of exfoliated BP, leading to the production of FL-BP flakes with an average lateral size and thickness of c.a. 30 and 7 nm, respectively. The use of acetone to produce less defective few-layer BP flakes (FL-BPacetone) from bulk crystals is a straightforward process which enables the rapid preparation of homogeneous thin films thanks to the fast solvent evaporation. The ratio of edge to bulk atoms for the BP flakes here produced, combined with the use of low-boiling-point solvents for the exfoliation process suggests that these thin films are promising anodes for lithium-ion batteries. To this end, we tested Li-ion half cells with FL-BPacetone anodes achieving a reversible specific capacity of 480 mAh/g at a current density of 100 mA/g, over 100 charge/discharge cycles. Moreover, a reversible specific capacity of 345 mAh/g is achieved for the FL-BPacetone-based anode at a high current density (i.e., 1 A/g). These findings indicate that the FL-BPacetone-based battery is promising with regards to the design of fast charge/discharge devices. Overall, the presented process is a step forward toward the fabrication of phosphorene-based devices.

Electrochemical Delamination of Ultralarge Few‐Layer Black Phosphorus with a Hydrogen‐Free Intercalation Mechanism

Growth of 2D Black Phosphorus Film from Chemical Vapor Deposition.

Ultrafast Electrochemical Expansion of Black Phosphorus Toward High-Yield Synthesis of Few-Layer Phosphorene

Improving Harsh Environmental Stability of Few‐Layer Black Phosphorus by Local Charge Transfer

Exfoliation of Few-Layer Black Phosphorus in Low-Boiling-Point Solvents and Its Application in Li-Ion Batteries

Ultrafast Laser-Shock-Induced Confined Metaphase Transformation for Direct Writing of Black Phosphorus Thin Films

Large-scale growth of few-layer two-dimensional black phosphorus

Wet Chemical Method for Black Phosphorus Thinning and Passivation.

Identification of Lattice Oxygen in Few-Layer Black Phosphorous Exfoliated in Ultrahigh Vacuum and Largely Improved Ambipolar Field-Effect Mobilities by Hydrogenation and Phosphorization

Synthesis of Crystalline Black Phosphorus Thin Film on Sapphire

High yield growth of centimeter-sized black phosphorus single crystal thin flakes through bidirectional vapor transport

Alkene-Catalyzed Rapid Layer-by-Layer Thinning of Black Phosphorus for Precise Nanomanufacturing

Progress in the synthesis of 2D black phosphorus beyond exfoliation

Electrostatic Functionalization and Passivation of Water-Exfoliated Few-Layer Black Phosphorus by Poly Dimethyldiallyl Ammonium Chloride and Its Ultrafast Laser Application.

Synthesis of thin-film black phosphorus on a flexible substrate

Electrochemical exfoliation of two-dimensional layered black phosphorus and applications

Solvent Exfoliation of Electronic-Grade, Two-Dimensional Black Phosphorus

A clean transfer approach to prepare centimetre-scale black phosphorus crystalline multilayers on silicon substrates for field-effect transistors

Passivation of Black Phosphorus via Self-Assembled Organic Monolayers by van der Waals Epitaxy.

Degradation Chemistry and Stabilization of Exfoliated Few-Layer Black Phosphorus in Water.

Environmental instability of few-layer black phosphorus