Abstract:Using magnetic field data to characterize the state of radio frequency (RF) printed circuit board (PCB) has been widely used in circuit state detection and fault identification. However, it may be difficult to measure the complete state of magnetic field radiation, so the characteristics of PCB may be challenging to establish, which makes the calculation method of reconstructing other radiation information of PCB with existing magnetic field information urgently needed. Based on the basic radiation principle of the electromagnetic field, we propose an algorithm that has advantages in reconstructing the magnetic field radiation state, in which the new single-layer iterative (NSLI) algorithm provides a more reasonable optimization range and field-source conversion matrix for the hybrid particle swarm optimization (HYPSO) algorithm, and converts the inverse problem of the large matrix into a forward optimization problem, further ensuring the accuracy and objectivity of the algorithm. According to the known magnetic field amplitude, this article uses a two-phase drive (TPD) circuit at 50-MHz frequency as a device under testing (DUT) to verify the proposed algorithm’s feasibility by reconstructing the complete 3-D magnetic field component radiated from the DUT and estimating the unknown magnetic field amplitude on the predicted plane. The specific experimental data show that when the magnetic field amplitude is known, the relative errors of the reconstructed magnetic field on the $x$ -, $y$ -, and $z$ -components are 1.9%, 0.02%, and 0.06%, respectively. In the meantime, under the actual measurement environment with a maximum relative uncertainty of 0.59%, the relative error of the magnetic field amplitude of the unknown predicted plane is 6.15%.

A Calculation Method for Reconstructing Radiation State of PCB Using Known Magnetic Field Amplitude Information

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

A hybrid domain decomposition and optimization method for predicting electromagnetic emissions from printed circuit boards

An iterative source reconstruction based method for radiated emissions prediction from PCBs

An Effective and Efficient Approach for Radiated Emission Prediction Based on Amplitude-Only Near-Field Measurements

A New Hybrid Equivalent Modeling Method of Low-Frequency Radiation Source Based on GS and JADE Algorithms and Phaseless Near-Field Data

A Method Based on Measured Boundary Conditions for Reconstructing the Magnetic Field Distribution of an Electromagnetic Mechatronic System

Reactive Magnetic Near-Field to Far-Field Transformation Based on Plane Wave Spectrum at PCB Level

A Novel Method for Locating PM Marker Based on Magnetic Field Reconstruction

Broadband Radiation Source Reconstruction Based on Phaseless Magnetic Near-Field Scanning

Equivalent Electromagnetic Hybrid Dipole Based on Cascade-Forward Neural Network to Predict Near-Field Magnitude of Complex Environmental Radiation

An efficient hybrid hot-spotting and optimization method for radiated emission compliance check

Near-Field Measurements Based Source Reconstruction Approach for Radiated Emissions Prediction

Radiated Emissions Prediction of an Electronic Packaging Based on Near-field Scanning

Equivalent Radiation Source of 3D Package for Electromagnetic Characteristics Analysis

A Particle Swarm Optimization-Based Approach for Predicting Maximum Radiated Emission From PCBs With Dominant Radiators

Hybrid Prediction Method For The Electromagnetic Interference Characteristics Of Printed Circuit Boards Based On The Equivalent Dipole Model And The Finite-Difference Time Domain Method

An Effective Equivalent Radiation Source Based on Near-field Scanning for Electromagnetic Interference Estimation

Radiation Diagnosis of PCBs and ICs Using Array Probes and Phaseless Inverse Source Method With a Joint Regularization

Reconstruction of the magnetic field in the measuring volume of an electromagnetic flow sensor

Source Reconstruction Method-Based Radiated Emission Characterization for PCBs