Abstract:This paper proposes a reactive magnetic near-field to far-field transformation method based on plane wave spectrum (PWS), aiming at electromagnetic radiation emission (RE) assessment at printed circuit board (PCB) level. Different from the antenna near-field measurement, the scanning plane is usually located in close vicinity of the device under test (DUT) in electromagnetic interference (EMI) near-field measurement, within the reactive region where evanescent waves are dominant. Additionally, in consideration of the presence of a ground plane on PCB, the tangential reactive electric near-field is minor, thus making it more common to measure the tangential reactive magnetic near-field. This further increases the difficulty of predicting far-field, which is commonly characterized by |E θ | and |E ϕ |. In this paper, the formula for magnetic near-field to far-field transformation is derived. Compared with the traditional dipole source reconstruction method, the proposed method eliminates the need for any intermediate steps and showcases an enhanced precision in predicting the far field of different examples. Additionally, the proposed method exhibits stronger robustness against noise interference, even in scenarios where the signal-to-noise (SNR) ratio is as low as 0 dB. Subsequently, numerical and experimental examples corroborate the effectiveness of the proposed mothed for reactive magnetic near-field to far-field transformation.

Reactive Magnetic Near-Field to Far-Field Transformation Based on Plane Wave Spectrum at PCB Level

Reactive Near-Field to 3-Meter Far-Field Transformation Based on Deep Convolutional Neural Networks and Plane Wave Spectrum

Broadband Radiation Source Reconstruction Based on Phaseless Magnetic Near-Field Scanning

A Hybrid Schatten P -Norm and Lp -Norm with Plane Wave Expansion Method for Near–Near Field Transformation

An Effective and Efficient Approach for Radiated Emission Prediction Based on Amplitude-Only Near-Field Measurements

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Near-Field Measurements Based Source Reconstruction Approach for Radiated Emissions Prediction

Reactive Near-Field to Far-Field Transformation Based on Equivalent Dipoles

An EM Imaging Method Based on Plane-Wave Spectrum and Transmission Line Model

Review of Near-Field EMI Measurement

An iterative source reconstruction based method for radiated emissions prediction from PCBs

Radiated Emissions Prediction of an Electronic Packaging Based on Near-field Scanning

An Effective EMI Source Reconstruction Method Based on Phaseless Near-Field and Dynamic Differential Evolution

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

Near-Field Radiation Estimation and Its Reduction Using a Novel EBG for PCB

EMI Source Reconstruction by Using Equivalent Dipoles at Different Height

A hybrid domain decomposition and optimization method for predicting electromagnetic emissions from printed circuit boards

A Measurement Verification for EMI Source Reconstruction Method Based on Amplitude-only Near-Field Scanning

Far-field Prediction from Amplitude-Only Near-Field Measurements Using Equivalent Electric Currents

An Effective Source Reconstruction Method of EMI Sources in Shielding Based on Phaseless Near-Field Scanning

The Far-field Estimation for Microstrip Line Based on Near-field Scanning