Abstract:From data collected by an online condition monitoring and fault diagnosis system, a higher pad temperature at the upper guide bearing in a pumped storage power generator unit installed in Guangdong province(GPSPS), China, was found. And also a relatively intensive shaft vibration occurred at the lower guide bearing. By calculating the Reynolds equation and viscosity-temperature equation of the lubricant, a curve between the pre-load coefficient and the increment of pad temperature is obtained, which shows that the larger, the pre-load coefficient, the bigger, the increment of pad temperature. For a practical unit in GPSPS, by employing Transfer matrix method and Wilson-theta method to analyze shaft vibration at different pre-load coefficients of the whole bearing or "pad pair" bearings, the results show that the larger the pre-load coefficient is, the smaller the vibration amplitude is, the shorter the time for vibration to become steady is. And an uneven pre-load coefficient of the "pad pair" bearings will cause shaft orbit from a circle to an ellipse whose long axes is at the direction of the "pad pair" with the lowest pre-load coefficient. Finally, reasons of higher pad temperature of the upper guide bearing and larger shaft vibration at the lower guide bearing are due to the inconsistent relation of bearing assembling clearance or pre-load coefficient of the upper and lower guide bearing, and also due to the too small, uneven pre-load coefficient of "pad pair" bearings. After a scheme for adjusting the bearing clearance is given, data measured show that the analysis and simulation methods are correct and the adjustment scheme to the assembling clearance of the upper and lower guide bearings is feasible and can be used to guide the field maintenance conveniently.

The improvement for overhauling methodology of turbine guide bearing

An Effective Method for Improving the Lifetime of Double Acting Vane Pump

Improvements of the Anchoring Method of the Removable Blades in a YL 33000A Gas Steam Turbines

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Aerodynamic Investigation on Retrofit for Turbine of a Turbo-Shaft Engine

Method Study on Reliability Improvement of Wind Turbine

Experimental Analysis of the Effect of Wear Factors on Guide Vane of Hydraulic Turbine

Influence Of Bearing Pre-Load Coefficient On Shaft Vibration And Pad Temperature In A Hydroturbine Generator Unit - A Case Study

Application of new techniques to renovation of 200 MW steam turbine

The Influence of Installation Deviation on the Upper Guide Bearing Thermo-Hydrodynamic Characteristics of a 1000 MW Giant Hydropower Unit

Analysis of the Influence of the Mechanical Imbalance and the Bearing Clearance on the Operating Stability of Hydro-power Unit

Reliability Improvement Method of Wind Turbine Gearbox

Hydraulic performance optimization of bidirectional tidal power turbine

Analysis and Treatment of Bearings Damage in 660MW Ultra-supercritical Turbine

Review of Wind Power Bearing Wear Analysis and Intelligent Lubrication Method Research

Thermal Adaptive Alignment Mechanism of Heavy-duty Gas Turbine Bearing Support

The Performance Improvement Study for the Seal Ring of the Oil Distribution Axle in Crankshaft and Rod Type Low Speed High Torque Hydraulic Motor

Influence of Guide Vane Profile Change on Draft Tube Flow Characteristics of Water Pump Turbine

Improvement on Super-Hydraulic Test Technology for Drum of Power Boiler Design Imported

Finite Element Analysis of Inner Hole Stress of Turbine Shrunk-on Disc

OPTIMAL METHODS OF THE DYNAMIC PROPERTIES IN A HYDROSTATIC BEARING SYSTEM