Abstract:In the past decades, Zirconia (ZrO2) has emerged as a promising technical ceramic, both as high temperature structural material and electrolyte for fuel cells, etc. The traditional synthesis of ZrO2 with spark plasma sintering (SPS) usually requires a sintering temperature as high as 1200 °C. General interest in lowering the sintering temperature to reduce energy consumption and thermal stresses has led to research on two promising routes – cold sintering via temperature-dependent chemical reactivity and sintering aids, which facilitates mass transport and improves densification. Here we combine both by developing a single-step sintering process benefitting from both water vapor through the in-situ conversion of Zr(OH)4 to ZrO2 and liquid phase Bi2O3 as a sintering aid. The resultant ZrO2 has a relative density above 80% with a sintering temperature as low as 900 °C, significantly higher than that of ZrO2 without sintering aids, which had a relative density of 54%, both sintered at 50 MPa. The dependence of porosity of sintered samples as a function of sintering pressure (range: 50 MPa–300 MPa) and temperature (range 400 °C–1200 °C) is mapped out as guidance for further material property design. A linear relationship between hardness and relative density was found, with a maximal hardness of 6.6 GPa achieved in samples with 30% porosity. In addition to sintered density, phase stabilization of tetragonal ZrO2 is enhanced at sintering temperature of 900 °C with water vapor and Bi2O3, respectively.

Surface hydrate-assisted low- and medium-temperature sintering of MgO

Densification of oxides via cold sintering of hydrate precursors

Densification and grain growth behavior of highly dense MgO ceramics in pressureless sintering

Cold sintering with dimethyl sulfoxide solutions for metal oxides

Microstructural evolution of ZnO via hybrid cold sintering/spark plasma sintering

Densification mechanism of ZnO ceramics prepared by cold sintering with molten zinc acetate dihydrate as the transient liquid medium

Sintering Behavior and Mechanical Properties of Spark Plasma Sintering SiO2-MgO Ceramics

Low-temperature densification of Mg2SnO4 ceramics with LiF-Fe2O3-V2O5 additive

The role of magnesium oxide addition in densification of AlON transparent ceramics by pressureless sintering

Effect of different MgO/Al2O3 ratios on microstructural densification, sintering process and mechanical property of MgAl2O4 materials

Synthesis of High Surface Area Nanometer Magnesia by Solid-State Chemical Reaction

Sintering characteristics and crystallization for sol–gel-derived powders for low-dielectric and low-temperature sintering ceramics

An easy approach to realize high thermal conductivity similar to single crystal and low hygroscopicity in magnesia sintered at low temperature

M- S-H formation in MgO-SiO2slurries via wet milling for magnesia based castables

Influence of bismuth oxide as a sintering aid on the densification of cold sintering of zirconia

Cold Sintering Assisted Processing of Mn-Zn Ferrites

Sintering and Performance of MgO from Bischofite with ZrO2 Additive

Sintering and Characterization of Flyash-Based Mullite with MgO Addition

Effects of MgO doping concentration on densification and microstructure of flash sintered α-Al2O3 ceramics

Effect of MgO Calcination Temperature on the Reaction Products and Kinetics of MgO–SiO2–H2O System

Demonstration of the cold sintering process study for the densification and grain growth of ZnO ceramics