Abstract:High primary rock stress can limit the generation of rock cracks caused by blasting, and blasting usually shows different rock breaking states under different primary rock stress conditions. There are a large number of naturally formed joints in rock mass, due to the limitations of laboratory tests, a numerical model of jointed rock mass was established using LS-DYNA software to investigate the evolution of blasting damage under various in-situ stresses and open joints. In this simulation, using the Lagrange-Euler (ALE) procedure and the equation of state (JWL) that defines explosive materials, the study considered different joint thicknesses (2cm, 4cm, and 6cm), joint angles (0°, 30°, 60°, and 90°), and in-situ stress conditions (lateral stress coefficients of 0.5, 1, and 2, with vertical in-situ stresses of 10MPa and 20MPa), through stress analysis and damage area comparison, the relationship between damage crack propagation and horizontal and vertical stress difference is explored. The research aimed to understand the mechanisms underlying crack initiation and propagation. The results show that: (1) The presence of joints exerts a barrier effect on the expansion and penetration of cracks. When explosion stress waves reach the joint surface, their propagation is impeded, leading to the diffusion of wing cracks at the joint ends. When the lateral stress coefficient and joint angle are the same, an increase in initial in-situ stress results in a reduction in the area of the blasting damage zone. (2) Under the same initial in-situ stress conditions, the area of the blasting damage zone initially increases and then decreases with an increasing joint angle. However, it remains larger than that without a joint, and there exists an optimal angle that maximizes the damage area. In the simulated conditions, the area of damage cracks is greatest when the joint angle is 60° dip angle. (3) The presence of initial in-situ stress has a certain impact on the initiation and expansion of blasting cracks. The degree and nature of this influence are not solely related to the lateral stress coefficient but also depend on the joint's angle and thickness. When in-situ stress is present, the initial in-situ stress field's pressure is not conducive to the initiation and propagation of blasting cracks. However, the existence of a joint has a noticeable guiding and promoting effect on crack propagation, and the pattern of crack propagation is influenced by both joint and in-situ stress conditions.

Effect of confining pressure on damage accumulation of rock under repeated blast loading

Effects of Confining Stress on Blast-Induced Damage Distribution of Rock with Discontinuity

Anisotropic Dynamic Damage and Fragmentation of Rock Materials under Explosive Loading

Numerical study on the behavior of blasting in deep rock masses

Numerical simulation of blasting behavior of rock mass with cavity under high in-situ stress

Study on cyclic blasting failure characteristics and cumulative damage evolution law of tunnel rock mass under initial in-situ stress

Experimental and numerical investigation on rock fracturing and fragmentation under coupled static pressure and blasting

Understanding the effect of differential stress and fracture geometry on blast-induced damage in crystalline rocks: a numerical approach

Investigation on Rock Fracturing in Presplit Blasting Under Various Initial Stresses

Numerical study on the dynamic fragmentation of rock under cyclic blasting and different in-situ stresses

Study on rock fracturing in smooth blasting under initial stress

Rate-dependent constitutive modelling blasting crack initiation and propagation in rock masses

Experimental study on the influence of intermediate principal stress on failure characteristics of strain rock burst for granite

Hard Rock Fragmentation in Percussion Drilling Considering Confining Pressure: Insights from an Experimental Study

Numerical modelling of blast-induced crack propagation in pre-fractured rock

Influence of confining pressure on rock fracture propagation under particle impact

Experimental Study of Failure and Morphology of Large Granite Specimens Under Confining Pressure and Blast Loading

Numerical simulation of rock blasting under different in-situ stresses and joint conditions

Study of rock damage characteristics in decoupled slit charge blasting based on computer tomography scanning

Fracture mechanics analysis of rock containing collinear cracks under dynamic blasting loads

Damage and Fragmentation of Rock Under Multi-Long-Hole Blasting with Large Empty Holes