Abstract:The objective of this paper is to present examples of efficient procedures for field measurement of live load, live load effect in bridge components, and proof load testing to verify the ultimate strength. The major truck parameters include gross vehicle weight (GVW), axle weights, and axle configuration (spacing). These parameters can be measured using weigh-in-motion technique, invisible to the drivers (to avoid bias). Stress spectra are important for prediction of the remaining life for bridge girders and details. These measurements should be performed over longer periods of time and they can be carried out using strain transducers. Monitoring of live load is an important element of evaluation of existing bridges. It has been confirmed that truck loads are strongly site-specific. Furthermore, load effects such as bending moment, shear and/or stress are component-specific. The objective of this presentation is to review some of the practical procedures used for field measurement of truck weights and strains. The truck load spectra for bridges are strongly site-specific. Bridges located on major routes between large industrial metropolitan areas will experience the highest extreme loads. Routes where vehicles are able to circumvent stationary weigh stations will have very high extreme loads. Bridges not on a major route, that are very near a weigh station, or that are within a metropolitan area experience much lower extreme loads. Live load stress spectra are strongly component-specific. Each component experiences a very different distribution of strain cycle ranges. The girder that is nearest the left wheel track of vehicles traveling in the right lane experiences the highest stresses in the stress spectra and decreases as a function of the distance from this location. This information can be useful to target bridge inspection efforts to the critical members. Proof load testing can be used as an efficient tool to verify the minimum ultimate strength of an existing bridge. A procedure has been developed at the University of Michigan which is based on using military tanks as proof load. Tanks provide an exceptionally heavy load (about 60 tons) over a short length (4.5 m). The test procedure will be demonstrated on several selected bridges recently tested in Michigan. The results indicate that many structures which are deficient by analytical methods of evaluation, can be justified by proof load tests. For the covering abstract see ITRD E111699.

Developing Efficient State Load Rating Vehicles Using a Heuristic Approach

Site-Specific Fatigue Load Spectrum for Urban Bridges

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

Bridge Rating Using System Reliability Assessment. I: Assessment and Verification by Load Testing

Improved bridge capacity rating methods based on system reliability assessment

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Bridge Rating Using System Reliability Assessment. II: Improvements to Bridge Rating Practices

Justification of the development and application of express assessment programs for road bridges when heavy vehicles pass through them

Development of Equivalent Stationary Dynamic Loads for Moving Vehicular Loads Using Artificial Intelligence-Based Finite Element Model Updating

Adaptive Equivalent Consumption Minimization Strategy for Off-Road Hydraulic Hybrid Vehicles: A Cycle-to-Cycle Optimization Approach.

DIAGNOSTIC AND PROOF LOAD TESTING FOR BRIDGE EVALUATION

Bridge Load Testing for Identifying Live Load Distribution, Load Rating, Serviceability and Dynamic Response

Reliability-Based Site-Specific Live Load Models for the Gordie Howe International Bridge

Traffic Hazards on Main Road’s Bridges: Real-Time Estimating and Managing the Overload Risk

Proof Load Testing Method by the American Association of State Highway and Transportation Officials and Suggestions for Improvement

Development of Probabilistic Temperature Loadsfor a PC Bridge in Oklahoma

Power Optimization Of Series Hydraulic Hybrid Powertrain For Compact Wheel Loader

Prediction of Maximum Live-Load Effects for Bridges Based on Weigh-in-Motion Data

WIM-based vehicle load models for urban highway bridge

A Study on Assessment Method of Traffic Load Effect of Bridge in Service

Measurement-Based Vehicle Load Model for Urban Expressway Bridges