Abstract:When subjected to repeated dynamic impacts at identical load level, a metallic monolithic beam/plate may reach a stable state wherein measurable deformation ceases (i.e., shakedown in elastic state) after undergoing a sequence of elastoplastic deformations, which has been termed as "pseudo-shakedown" (P-S) (Jones, 1973; Shen and Jones, 1992). While the response of a single beam/plate under repeated low-velocity impacts has been thoroughly studied, its dynamic behavior under high-velocity impacts, such as explosive or alternating impulsive loads, is difficult to measure experimentally, due mainly to high costs and setup challenges. In the current study, the method of metallic foam projectile impact was employed to produce repeated impulsive loadings on a fully-clamped elastoplastic monolithic plate made of L907A (a Chinese standard shipbuilding steel). Its dynamic responses, including mid-point deflection versus time histories, final deflections, and deformation modes after each impact, were systematically measured. The phenomenon of dynamic shakedown was observed. To further explore this phenomenon, the method of finite elements (FE) was employed to simulate the repeated impulsive impact test, and its prediction accuracy was validated against experimental results. Unlike an elastoplastic (e.g., steel) monolithic plate subjected to repeated low-velocity impacts, which exhibits zero plastic energy dissipation in the P-S (pseudo-shakedown) state, the same plate under repeated high-velocity impacts shows a small level of plastic energy dissipation in the P-S state, mainly due to more extreme loading conditions. The initial impact momentum, yield strength, and tangent modulus of the material the plate is made of significantly affect both the stable deflection in the P-S state and the number of impacts needed to reach it, while the elastic modulus has limited influence. A modified dimensionless impulse loading number, accounting for the strain-hardening effect, is proposed. An approximately linear relationship between stable deflection in the P-S state and impulsive loading is found in dimensionless form.

Impulse saturation in metal plates under confined blasts

Dynamic Response Mechanism of Thin-Walled Plate under Confined and Unconfined Blast Loads

Analysis of the Dynamic Response in Blast-Loaded CFRP-Strengthened Metallic Beams

Double blast loadings of clamped square steel plates

Preliminary Assessment of Sandwich Plates Subject to Blast Loads

Confined blast loading of steel plates with and without pre-formed holes

Centrifuge Experiment and Numerical Analysis of an Air-Backed Plate Subjected to Underwater Shock Loading

An analytical method for evaluating the dynamic response of plates subjected to underwater shock employing Mindlin plate theory and Laplace transforms

An experimental study of the effects of degrees of confinement on the response of thermoplastic fibre–metal laminates subjected to blast loading

Dynamic Response and Damage Assessment of Partially Confined Metallic Cylinders Under Transverse Blast Loading

Saturated Impulse of Elastic-Plastic Beams under Concentrated Pulse Force

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Numerical Study of Flat Plate Impact on Water Using a Compressible CIP–IBM–Based Model

Blast responses of steel stiffened panels subjected to plane shock waves

Failure Mechanisms in Composite Panels Subjected to Underwater Impulsive Loads

Metal sandwich plates optimized for pressure impulses

Blast mitigation by perforated plates using an explosive driven shock tube: study of geometry effects and plate numbers

Elastoplastic plate shakes down under repeated impulsive loadings

Mechanical Response of Metallic Honeycomb Sandwich Panel Structures to High-Intensity Dynamic Loading

Experimental and numerical study of corrugated steel-plain concrete composite structures under contact explosions

Large inelastic response of polyurea-coated steel plates to confined blast loading