Abstract:In recent years, structural adhesives have rapidly become the preferred alternative to resistance spot welding in fabricating stronger, lighter aluminum connections. Connections inevitably undergo and must withstand complex quasi-static and/or dynamic loads during their service life. Therefore, understanding how loading conditions affect the mechanical behavior of adhesive joints is vital to their design and the advancement of structural safety. Quasi-static and dynamic tests are performed to analyze both the strength and failure modes of aluminum 6062 substrates bonded by an adhesive (Darbond EP-1506) for an array of loading directions. An Arcan test device, which enables application of mixed-mode loads ranging from pure peel (mode I) to pure shear (mode II) to the adhesive layer, is employed in quasi-static testing. A self-designed medium-speed test machine is utilized to perform dynamic testing. To avoid severe system oscillations exhibited in force measurements during dynamic testing, the Arcan test device is replaced by a set of integrated fixtures to improve stiffness and reduce fixture weight. To induce manifold mechanical responses in the adherend and adhesive materials, the specimens are subjected to a mixture of transverse and shear forces. Experimental results demonstrate that the fracture displacement increases with an increase in testing angle of the applied force, indicating that ductile fracture predominates brittle fracture and governs failure when shear loading is significant in mixed loading scenarios, especially for dynamic tests. Furthermore, dynamic strengthening is observed in samples subjected to peel loading, but is undiscovered in samples tested under mixed loading conditions, where interfacial failure is more likely to occur compared to cohesive failure. This observation reveals that the cohesive zone is reinforced by the strain rate effect, whereas the interface between the adhesive and adherend does not experience this phenomenon.

Dynamic fracture response of adhesive joints subjected to mode-I impact wedge loading

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

Fracture energy and cohesive law analysis of adhesives using a recently developed SCB joint: The influence of joint geometry and mode mixity

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Analysis of the adhesively bonded composite double cantilever beam specimen with emphasis on bondline constraint, adherend through-thickness flexibility and fracture process zone relative size

Investigation on the Stable and Stick-Slip Crack Propagation Behaviors in Double Cantilever Beam Test

Influence of Loading Rate on the Cohesive Traction for Soft, Rubber-like Adhesive Layers Loaded in Modes I and III

Dynamic mode-I delamination in composite DCB under impact loads with attunable dynamic effect

On the Fracture Resistance of Adhesively Jointing Structures

Finite Element Analysis of Crack Propagation in Adhesive Joints with Notched Adherends

Investigation of traction-separation behavior in adhesively bonded joints under mode I and mode II loading using DIC technique and FEA

Experimental Investigation of the Mechanical Behavior of Aluminum Adhesive Joints under Mixed-Mode Loading Conditions

Finite Element Analysis of Low-Speed Oblique Impact Behavior of Adhesively Bonded Composite Single-Lap Joints

Determination of fracture toughness of an adhesive in civil engineering and interfacial damage analysis of carbon fiber reinforced polymer–steel structure bonded joints

Dynamic Failure Analysis Of Bimaterial Beam With Crack-Tip Terminating Interface

Mode II fatigue characteristics of a composite bonded joint with microstructured adhesive bondline through tailored sacrificial cracks

Determination of Interface Fracture Toughness of Adhesive Joint Subjected to Mixed-Mode Loading Using Finite Element Method

Estimating crack tip position in adhesively bonded joints subjected to mode II quasi‐static loading

Estimation of Crack Tip Position in Adhesively Bonded Joints Subjected to Mode II Fatigue Loading

Fracture Analysis of Highly Flexible Adhesives: Cohesive Zone Modelling across a Wide Spectrum of Temperatures and Strain Rates

Mode I fracture toughness of asymmetric metal-composite adhesive joints