Abstract:Narrow-band response photodetectors are widely used in situations where specific light wavelengths need to be detected, such as communication. imaging, surveillance, etc. These detectors require not only the narrowest spectral response window, but also the highest external quantum efficiency (EQE) within the response window. Generally, the semiconductor photoactive layer in the photodetector will absorb the photons with energy greater than the band gap, and the spectral response window is usually wide, so it needs to combine with the filter of specific wavelength to achieve narrow band response. However, the introduction of filters, in addition to the increased cost, will inevitably lead to additional light reflection losses, which will significantly reduce EQE. When the film thickness of the heterojunction is up to inn, the narrow-band response near the band edge can be achieved without a filter. However, the problem brought by thick film is that the photocurrent also decreases, resulting in lower EQE (<30%) of the device. Although higher reverse bias increases the photocurrent and EQE, it also increases the collection probability of short-wave photogenerated carriers, thus damaging the narrow-band response. By greatly reducing the proportion of organic receptors and donors in the micron-size photoactive layer, the narrow-band response window of ca. 650 mu was achieved, and the EQE was up to ca. 53500% under -60 V reverse bias. This kind of organic photodetector achieving the photomultiplication mainly attributes to the trapped charges at the photoactive layer/electrode interface which will capture the photogenerated electrons (holes), and when the photogenerated electrons (holes) are collected, the electric neutral balance in the photoactive layer is broken. The trapped photogenerated electrons (holes) at the interface will cause the change of interface potential energy, which induces the interface band bending of the photoactive layer, and promotes the metal electrode to inject holes into the photoactive layer to maintain the neutral balance. Because the injection current is much higher than the photoelectric current, the superposition of the two can significantly increase EQE and even produce gain. However, the idea of obtaining higher EQE by further increasing the concentration of interfacial trapped electrons is difficult to be realized by increasing the proportion of receptors, which not only reduces EQE, but also increases the full width at half maximum (FWHM) of the response window and destroys the narrow-band response. In this work, the structure of ITO/poly(3,4-ethylenedioxythiophene):polystyrene sulfonate (PEDOT)/poly(3-hexylthiophene) (P3HT)/[6,6]-phenyl-C61-isomethyl butyrate (PCBM)/aluminum (Al) has been prepared. By optimizing the thermal annealing time and PCBM concentration, the EQE at -60 V was successfully improved from 52946.8% to 68470.9%, which is the highest gain of narrow-band response organic photodetector so far, and the FWHM of ca. 28 tun remains unchanged. We used Nano-IR to confirm that EQE enhancement was attributed to thermal annealing induced diffusion of PCBM into P3HT, thus optimizing the electron trap concentration distribution at the interface between the active layer and the metal top electrode and enhancing carrier injection.

In Operando Visualization of Interfacial Band Bending in Photomultiplying Organic Photodetectors

Improving the Photomultiplication in Organic Photodetectors with Narrowband Response by Interfacial Engineering

Interfacial Electron Transfer of P3HT/PDI/ZnO Nanocomposite and Its Application in Visible-Light Detection

Broadband photoresponse promoted by interfacial electron transfer in diketopyrrolopyrrole-based compound/ZnO hybrid nanocomposites

Engineering of Interfacial Electron Transfer from Donor-Acceptor Type Organic Semiconductor to Zno Nanorod for Visible-Light Detection

Quantitative o perando visualization of the energy band depth profile in solar cells

Quantification of an Effective Charge Injection Barrier in Non-Fullerene-based Organic Photodetectors

The Light Wavelength, Intensity, and Biasing Voltage Dependency of the Dark and Photocurrent Densities of a Solution-Processed P3HT:PC61BM Photodetector for Sensing Applications

Transient analysis of photomultiplication-type organic photodiodes

Role of interfaces in controlling charge accumulation and injection in the photodetection performance of photomultiplication-type organic photodetectors

Organic Bulk–Heterojunction Blends with Vertical Phase Separation for Enhanced Organic Photodetector Performance

Identifying the Molecular Origins of High-Performance in Organic Photodetectors Based on Highly Intermixed Bulk Heterojunction Blends

Tailoring The Energy Band In Flexible Photodetector Based On Transferred Ito/Si Heterojunction Via Interface Engineering

Optimization of Broad-Response and High-Detectivity Polymer Photodetectors by Bandgap Engineering of Weak Donor-Strong Acceptor Polymers

Non‐Traditional Positively‐Biased Narrow‐Band Perovskite Single‐Crystal Photodetectors Enabled by Interfacial Engineering

Enhancing sub-bandgap external quantum efficiency by photomultiplication for narrowband organic near-infrared photodetectors

Photomultiplication Enabling High‐Performance Narrowband Near‐Infrared Organic Photodetectors

Revealing The Working Mechanism Of Polymer Photodetectors With Ultra-High External Quantum Efficiency

Efficient Charge Transfer in Narrowband Organic Photodiodes Based on Self-Assembled Heterojunction for Spectrally Selective Photodetection and Imaging

Simultaneous Photomultiplication Improvement and Response Acceleration for High-Performance Lateral Polymer Photodetectors Based on Bulk Heterojunction

Organic Near‐infrared Photodetectors with Photoconductivity‐enhanced Performance